Abstract:Constructing large-section underground structures using the pipe jacking technique presents challenges, including the insufficient size of the rectangular pipe-jacking machine and the transportation and hoisting of large prefabricated ring structures. This paper introduces and investigates the construction, challenges, and key techniques involved in jacking a super-large rectangular prefabricated tunnel underpass a rainwater box culvert. The adoption of an assembly concept for manufacturing both the super-large rectangular pipe-jacking machine and ring structures, along with innovative in-shaft assembly and jacking techniques, effectively addresses issues in super-large section pipe-jacking engineering. The on-site monitoring data analysis reveals that the jacking force for the super-large rectangular tunnel significantly exceeds the estimated value. This is primarily attributed to excessive resistance during jacking in the reinforcement areas of the launching and receiving shafts, constituting 55 % of the total jacking force. Additionally, the jacking resistance from the soil chamber pressure accounts for approximately 22 % of the total force. The frictional resistance of the ring structures represents only 23 % of the total jacking force, with the average surface friction force approximately at 12.4 kPa. Vertical and horizontal relative deviations of the tunnel were controlled at 32 mm and 22 mm, respectively. The settlements of the ground surface and box culvert induced by pipe-jacking were vulnerable to the grouting pressure of lubricants, with maximum values of 35.9 mm and 39.1 mm, respectively. The experience learnt from this project can provide valuable insights for the application of large-section rectangular pipe-jacking technology in underground space development.

Design and Construction Technology of Large-diameter Non-excavated Tractive Pipe

On Quality Control and Application Perspective in Large-Pore Steel Corrugated Pipe Culvert Construction

Innovative Design of Pipe Piles Combined Both the Effect of Pile Foundation and Composite Foundation for Soft Soil Treatment

Application of Large-Diameter Thin-Wall Cast-in-situ Concrete Pipe Piles in Ocean Structures

TRIAXIAL MIXED PILE JOINT DEWATERING METHOD FOR CONSTRUCTION OF PASSAGE CONNECTING TUNNELS

Environmental Effects Caused by Construction of Rectangular Jacking Pipes with Large Section, Small Space and Shallow Overburden

CASE STUDY ON THE LARGE DIAMETER PIPE JACKING FOR UTILITY TUNNEL

Design and construction of precast reinforced concrete drain pipe in water conservancy project

The Application of Non-Excavation Pipeline Rehabilitation Technology in Power Plants Water Pipelines

Case Study of the Largest Concrete Earth Pressure Balance Pipe-Jacking Project in the World

Study on the Design and the Application of the Groundwater Recharge System in Excavation

Construction of a super-large prefabricated rectangular tunnel beneath a box culvert using pipe jacking: A case study

New Form of Pipe Foundation on Deep Weak Subgrade

Management and Construction Strategy of Water Supply and Drainage Engineering

Research on Pipe Jacking Construction Technology Based on Upcrossing Metro and Cable Tunnel

Analysis of Water Supply and Drainage Construction Technology for Municipal Engineering

Research on tubular segment design of submerged floating tunnel

Construction Techniques for Reinforcement of Foundation of Existing Bridge Pile with Microsteel-Piped Pile

Technology of Double Pipe and Non-Shrinkage Double Liquid Grouting WSS of Beijing Subway Line 10

Discussion on Underground Engineering Construction Technologies of Urban Rail Transit

Application Research of GPR in Quality Detection of Urban Underground Jacked Pipes Construction