Abstract:In order to study the axial compression performance for composite hollow column of steel fiber, high-strength lightweight aggregate concrete and angle steel, the axial compression tests were carried out on five composite hollow columns of steel fiber, high-strength lightweight aggregate concrete and angle steel with the variation parameters of hollow ratio (0%, 15%, 16%, 32% and 36%) and the form of opening (round hole and square hole). The failure phenomena and failure forms of the specimens were observed, and their stress–strain curves were measured, and the axial bearing capacity formula suitable for composite hollow column of steel fiber, high-strength lightweight aggregate concrete and angle steel was established. The following conclusions may be obtained from the test results: the axial compression performance for the composite hollow columns of angle steel is influenced by the hollow ratio and opening form greatly. The axial compression performance for composite hollow columns of steel fiber, high-strength lightweight aggregate concrete and angle steel is almost close to that of composite solid columns when the hollow ratio is low; The higher the void ratio, the more the cracks at the surface of the concrete, some transverse cracks appear, the peak load decreases by about 5–38%, and the deformation ductility coefficient increases gradually; The deformation ductility coefficient of round-hole hollow column is lower than that of square-hole hollow column. Based on the test, the finite element software ABAQUS is used to simulate the SCAH column. The correctness of the model is verified via the comparison between the numerical simulation results and the test results. At the same time, the stress nephogram of concrete and steel at different stages and the stress nephogram at concrete restraint state are simulated. According to the finite element simulation results, Mander model is used to calculate the axial compression bearing capacity of composite hollow column of angle steel. The high calculation accuracy and suitable for popularization can be obtained.

Experimental and Numerical Investigation on Crush Resistance of Polygonal Columns and Angle Elements

Experimental and Numerical Study of 7A04-T6 Extruded Aluminium Alloy Lipped Angle Columns in Axial Compression

Experimental and Numerical Study on the Behavior of Circular RC Columns under Impact Loading

Numerical Simulation Analysis and the Program for Steel-Concret Composite Long Column in Eccentricaly-loaded

Collision and Rebound Behavior of Elastic Circular Ring Impinging on Elastic Column

Experimental Studies on Glubam Columns under Axial Compression

Numerical study on the axial collapse of thin-walled columns

Numerical Investigation and Design of Thin-Walled Complex Section Steel Columns

Numerical Investigation on Compressive Performance of CFST Columns with Encased Built-Up Lattice-Angles

Crushing and energy absorption of density-graded foam-filled square columns: Experimental and theoretical investigations

Energy absorption properties of non-convex multi-corner thin-walled columns

Energy absorption of multi-cell stub columns under axial compression

Numerical Analysis on Concrete-Filled Wide Rectangular Steel Tubular (CFWRST) Stub Columns under Axial Compression

Axial Compressive Behavior of FRP-confined Square CFST Columns Reinforced with Internal Latticed Steel Angles for Marine Structures

Axial Crushing of Triangular Tubes

Experimental and Numerical Investigation on the Crushing Behavior of Sandwich Composite under Edgewise Compression Loading

Mechanical Behavior of Cross-shaped Partially Encased Composite Columns under Axial Compression

Experimental study on axial compression for composite hollow column of steel fiber, high-strength lightweight aggregate concrete and angle steel

Accurate modelling of the crush behaviour of thin tubular columns using material point method

Crushing mechanical responses of natural wood columns and wood-filled composite columns

Quasi-static crushing behaviors and plastic analysis of thin-walled triangular tubes