Abstract:This paper presents an experimental study of the effect of the mass of dust retained on a fibrous filter bed operating singly and in a "cyclone-filter-bed" system on changes in filtration efficiency and accuracy, as well as the increase in flow resistance. The research was carried out using a novel and unprecedented method, determining the dust absorption coefficient km of the filter baffle under laboratory conditions. A filtration system built of a single cyclone and a cylindrical filter cartridge with an appropriately sized surface set behind it was studied. Conditions corresponding to the actual operating conditions of the air filter were maintained: dust concentration, filtration speed and dust extraction from the cyclone settling tank. The purpose of the research was to evaluate filter materials with different structures in terms of filtration efficiency and accuracy, as well as flow resistance. The study showed that the parameters of the structure of filter materials—permeability, grammage and thickness—affect the process of retaining dust particles. It was shown that the increase in the flow resistance of the filter bed has a higher intensity when dust grains of small sizes are directed at it, which is the case when the bed is operated behind a cyclone, which separates larger dust grains from the air. There is a reduction in the operating time of the filtration system due to the limitation of the permissible resistance ∆pfdop, and the corresponding dust absorption km has a lower value. For a fixed value of the flow resistance, the dust absorption coefficient km2 of three different filtration baffles AC, B2, and B, working with a cyclone, take values 50–100% smaller than when working in a single-stage system. It has been shown that the "cyclone-filter baffle" unit, due to its greater dust separation capability, allows the filter cartridge to operate for a longer time until a certain flow resistance is reached. This allows the unit to operate longer at lower flow resistance without changing the filter cartridge, thus saving energy. The km values obtained during the tests, using the proposed original method, allow the selection of the filter bed for specific vehicle operating conditions by modelling its course.

TEST SIMPLIFICATION IN EVALUATING THE DYNAMIC DUST-REMOVAL BEHAVIOR OF FILTERING MATERIAL IN THE DUST COLLECTOR

Study on the Influence Mechanism of Filtering Parameters in Wet Filtration Dust Removal System

Performance optimization of rectangular flat pleated filter with slit nozzle for dust cleaning

The Performance Testing and Analysis of Common New Filter Materials: A Case of Four Filter Materials

Development of an asymmetric composite PPS-based bag-filter material through membrane laminating and superfine fiber blending: Lab test, field application and development of numerical models

Reverse pulsed-flow cleaning for filtration unit regeneration: A review

Experimental investigation on filtration characteristic with different filter material of bag dust collector for dust removal

Experimental Study on Resistance Influencing Factors of Clean Filter Material Used in Air Purification

Effects of Filter Cartridge Wetted Before Filtration and During Filtration on the Performance of Cartridge Dust Collector

Experimental Testing of Filter Materials for Two-Stage Inlet Air Systems of Internal Combustion Engines

Dust dispersion during the pulse-jet cleaning process with the diffuser effect of the cartridge filter

Dust Loading Performance of a Novel Submicro-Fiber Composite Filter Medium for Engine

Preparation and performance characteristics of an environmentally-friendly agglomerant to improve the dry dust removal effect for filter material

Experimental investigation on low-pressure pulse dust cleaning performance of plate-frame microporous membrane filter media

Effect of Pre-Cladding Dust Layer on Filtration and Pulse-Jet Cleaning Performance of Filter Media

Numerical study of pleated fabric cartridges during pulse-jet cleaning

Experimental study on the synthetic dust loading characteristics of air filters

Performance optimization of airliner cabin air filters

Study of the Influence of Types of Dust Sources on the Dynamic Filtration Performance of Air Filtration Materials

Energy consumption performance optimization of PTFE HEPA filter media during dust loading through compositing them with the efficient filter medium

Study on Effects of Particle Size and Maximum Pressure Drop on the Filtration and Pulse-Jet Cleaning Performance of Pleated Cartridge Filter