Abstract:Laser surface texturing technology including the steps of surface pre-processing, laser texturing, and surface post-polishing was utilized to process typical micro-dimples(diameter 50 μm, depth 8 μm, and area ratio 10%) on the cylinder liner surface in a production engine. By conducting the reciprocating friction tests on a friction-wear tester, the instantaneous friction force of the real cylinder liner-piston ring pair was measured for comparing the tribological performance of plateau-honed cylinder liner and laser-textured cylinder liner. The testing results showed that under different lubrication conditions, laser texturing cylinder liner could effectively reduce the friction force, especially the peak force around the reciprocating stroke ends of ring/liner pair. Within a reciprocating stroke, the average friction coefficients of the laser-textured cylinder liner-piston ring pair decrease by approximately 18.6%–37.6% under low temperature oil bath condition dominated by hydrodynamic lubrication, while the friction coefficients decrease by approximately 1.8%–6.1% under high temperature oil bath condition dominated by mixed lubrication compared with these of the plateau-honed cylinder liner-piston ring pair. This indicates that laser texturing cylinder liner with appropriate micro structures could enhance the hydrodynamic effects and reduce the friction of ring/liner system, which is conducive to improving the engine mechanical efficiency and the application of low-friction design on production engine.

Study on Remanufacturing technology of Cylinder Liner/Piston Ring for Armored Equipment Engine

Research of Oil Cylinder's Airproof Technology

A Study on Heat Transfer Model for the Dynamic Contact Boundary Between Piston Ring and Cylinder Liner

Application Research of Auto-reconditioner for Worn Metals on DF Locomotive Diesel Engines

IMPROVING THE PROCESSING QUALITY OF CYLINDER LINERS USING COMBINED TECHNOLOGY

Reciprocating sliding friction behavior and wear state transition mechanism of cylinder liner and piston ring

Researches of Cast Iron Piston Rings Strengthened by Laser

Molecular Dynamics Investigation on Micro-Friction Behavior of Cylinder Liner-Piston Ring Assembly

Experimental research on the frictional performance of real laser-textured cylinder liner under different lubrication conditions

Tribological Performance and Scuffing Resistance of Cast-Iron Cylinder Liners and Al-Si Alloy Cylinder Liners

Study on the defects analysis and design technology improvement of marine diesel engine piston

Emergence of Coated Piston Ring Scuffing Behavior on an Application-Oriented Tribological Model Test System

A review on preparation process and tribological performance of coatings for internal combustion engine piston ring

In situ mechanochemical reconditioning of worn ferrous surfaces

Relationship between Cylinder Liner Deformation and Friction Work of Piston Ring

A study on the restoration method of friction, wear and fatigue performance of remanufactured crankshaft

Wear Performance of Cast Iron Piston Rings Strengthened by Laser

Investigation On The Performance Of Compression Ring-Cylinder Liner System Under Starved Lubrication

Piston ring–liner lubrication and tribological performance evaluation: A review

Study of Friction and Wear Characteristics of Cylinder Liner Piston Ring in Engine

Equal–Additive–Subtractive Remanufacturing Integrated Laser Directed Energy Deposition with Shot Peening and Machining Induced High Performance of Plunger Rod