Abstract:It was discussed that the research progress and technical achievements had been obtained in the field of residual stress measurement and control of high-grade and large-diameter welded pipe for oil and gas transportation in China. (1) The layout scheme of measuring points and the requirements of spaces between measuring points, hole depth, etc., for residual stress measurement of welded pipe using hole drilling strain-gage method were proposed. On which, the residual stress measurement technology for welded pipe was proposed. (2) The measurement results indicate that the characteristics and distribution of residual stress of SAWH pipes with different grades and sizes were quite different. In general, the residual stress of SAWH pipe was highest, followed by JCOE pipe and UOE pipe. After the ring splitting test, SAWH pipe section usually had relative displacement in circumferential, axial and radial directions, and the degree of deformation varies greatly; But SAWL pipe section usually only occurs circumferential opening, without axial and radial stagger, and the circumferential opening of JCOE pipe was usually larger than that of UOE pipe. (3) Based on the mechanical analysis of the complex deformation of SAWH pipe after the ring splitting test and the superposition principle of elastic mechanics, a prediction model of the residual stress of the high-grade and large-diameter welded pipe suitable for SAWH pipe was established, which overcame the deficiency of the existing prediction models of the residual stress of the welded pipe only considering the circumferential deformation. (4) The key forming parameters affecting the residual stress of SAWH pipe were analyzed and determined as the reduction and forming angle. Combined with the finite element simulation analysis, field adjustment and residual stress analysis, the forming technology and residual stress control technology of low residual stress SAWH pipe were developed.

Test Methods for Residual Stress in Large-diameter Welded Pipe of High Grade Steel

Research on Residual Stress Distribution Rule of 3 Kinds of Large Diameter Welded Pipe with High Grade

Measurement and Control of Residual Stress of High-Grade and Large-Diameter Welded Pipe for Oil and Gas Transportation

Assessing the Residual Stresses in Dissimilar Welded Joint: Depth-Sensing Indentation Testing and Numerical Simulation

Fatigue Testing in Welded Joint of 980- grade Steels

Prediction of Residual Stress Distributions in Welded Sections of P92 Pipes with Small Diameter and Thick Wall Based on 3D Finite Element Simulation

Research Progress and Prospect of Residual Stress in Welded Pipe

Welding residual stress analysis of the X80 pipeline: simulation and validation

Safety Test Research of Pressure Pipes Containing Incomplete Welding Defects

Finite Element Analysis of Modeling Residual Stress Distribution in All-position Duplex Stainless Steel Welded Pipe

Research on Welding Residual Stress Measurement Using Electromagnetic Acoustic Transducer

3D finite element analysis and optimization of welding residual stress in the girth joints of X80 steel pipeline

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Numerical Studies on Double Wire Submerged Arc Welding Residual Stress of X80 Steel Spiral Pipe

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

Experimental Investigation and Modeling on Residual Stress of Welded Steel Circular Tubes

Three-dimensional Finite Element Analysis of Residual Stresses in Circumferential Welds of 2205/X65 Bimetallic Pipe

Finite Element Analysis of Welding Residual Stress of Stainless Steel 304 Half-pipe Jacket

Measuremnet of Welding Residual Stress of T92 Steel Tube Based on Blind-hole Method

3-D Finite Element Analysis of Welding Residual Stress for Half-Pipe Jacket Made of 304 Stainless Steel

Residual stress simulation in thin and thick-walled stainless steel pipe welds including pipe diameter effects