Abstract:A novel angle track converter for sinusoidal encoders has been proposed. Firstly, the four‐phase sinusoidal signals are reshaped according to the signal periodicity. Then a fine angle interpolation is adopted based on analog division and arctangent algorithm. The integrated converter only occupies 0.16 mm2 active silicon area and consumes 1.5mW at the sample rate 10 MHz. Final measurement error is within 1.8° in the full range. The proposed angle track converter has a significant advantage in cost, speed, and efficiency. This paper presents a novel angle track converter for sinusoidal encoders. These encoders provide electronic signals in which the position is encoded in sinusoidal form. This work aims to reduce the complexity and enhance the conversion speed of the sinusoidal‐to‐angle demodulation system. Considering the periodicity of sine and cosine signals (SCSs), the full range [0,2π) is evenly divided into eight segments to determine the coarse angle. According to the specific coarse angle segment, the SCSs are reshaped for proceeding demodulation. Then a fine angle is derived from reshaped signals based on division and arctangent algorithm. Division operation is achieved by a capacitor digital‐to‐analog converter, dynamic comparator, and successive approximation register. The arctangent value is obtained from the division result with the compensation by a small‐size look‐up table. The new converter fabricated in 0.18‐μ m BCD technology occupies an active area of 0.16 mm2 and consumes 1.5 mW at the sample rate 10 MHz. The measured maximum error is 1.8°, in the full range. Without analog‐to‐digital converters and no nonlinear operation unit, the proposed angle track converter has a significant advantage in cost, speed, and efficiency.

A synchro angle measuring system based on AD2S83 and DSP

A FPGA Stereo Matching Algorithm Modeled by DSP Builder.

Improved Design Scheme of High Accuracy Harmonic Detection Based on DSP

Comparison Of Dsb And Ssb Demodulation Methods In General Control System Of Mems Gyroscopes

High-Precision Attitude Angle Measuring System Based on Talbot Interferometry

DSP Based All-Digital Resolver-to-digital Conversion Using DSRF-PLL

Digital Detection and Optimization Design for Resonant Fiber Optic Gyroscope

A Successive Approximate Angle Track Converter for Sinusoidal Encoders

Design and realization of the angle-measurement algorithm of the four-quadrant detector based on the interpolation algorithm

A Novel All-Digital Resolver-to-Digital Conversion System Based on Numerical Synchronous Integration.

Design of Linear CCD High-Speed and High-Precision Measurement System Based on DSP

A Soft Decoding S Trategy for the Resolver in Motor Drive System

Software-Based Resolver-to-Digital Converter Using an α-β-γ Filter

Digital Control and Performance Test of a Symmetrical Doubly Decoupled Micro-Machined Gyroscope

Design of Measurement System for Phase Difference Based on DSP

Design and test of the interface of the dual-chip integrated digital silicon gyroscope ASIC

Digital Amplitude Demodulation for Micro Gyroscope with Levitated Rotor Based on DSP

Development of DSP-based measurement system of balancing machines

An Encoding ASIC With Real‐Time Correction for Inductive Angular Sensing Systems

A Novel Absolute Angle-Measuring Method With Rotary Inductosyn

The design and initial testing of the beam position measurement system in SSRF based on fully digital signal processing