Abstract:A composite titania thin film consisted of quasi-aligned single-crystalline rutile nanorods embedded in sol-gel-derived anatase aggregates was fabricated and its photoelectrochemical behavior was studied in detail. A monolayer of nearly sing I e-crystal line rutile nanorods was first deposited on metallic Ti substrates through a controlled reaction between Ti and hydrogen peroxide. The gaps among the rutile nanorods were then filled with titania nanoparticles through a sol-gel dip-coating approach, which achieved a composite thin film of single-crystalline rutile nanorods embedded in anatase aggregates, after a subsequent thermal treatment at 723 K. The X-ray diffraction measurement revealed that the composite film with thickness of 180 nm contained anatase and rutile in a nearly 50:50 ratio. The UV-visible diffusive reflectance spectra estimated a band gap of 2.99 eV for the rutile monolayer and a slightly increased value of 3.03 eV for the composite film due to the embedding of the anatase nanoparticles. Photocurrent versus potential diagrams, photocurrent transient curves, and open-circuit potential measurement supported the fact that the anatase nanoparticles possessed better inherent photoelectrochemical properties than rutile. However, electrochemical impedance spectra characterization, together with photocurrent transient curves and open-circuit potential measurement, suggests that the single-crystalline rutile nanorods exhibited a higher electron-transfer rate. The combination of the two components in such an appropriate way enhanced significantly the charge separation effect arising from the anatase/rutile couple, which hence combined efficiently the "mixed crystal effect" and the "mixed morphological effect". A steady-state photocurrent more than double the simple sum of those generated by the two components alone was detected for the current composite film, which can be attributed to the single-crystalline rutile nanorods that provide channels for rapid electron transfer to the conductive Ti substrates under an applied bias potential. As a result, this study concludes that the present nanostructure magnified significantly the well-established mixed crystal effect, that is, an enhanced charge separation arising from a mixture of anatase and rutile.

Photoelectrochemical properties of TiO2 coated on carbon nanofibers with different microstructure film electrodes

Photo-Induced Charge Generation of TiO<sub>2</sub> Nanotube Modified with Polymer Containing C<sub>60</sub> under Irradiation of Visible Light and its Applications

Highly-enhanced Performance of TiO 2 Nanotubes Attached with CdS quantum Dots

Polymer-Derived Carbon Nanofiber and Its Photocurrent-Switching Responses of Carbon Nanofiber/Cu Nanocomposite in Wide Ranges of Excited Light Wavelength

Electrodeposited Cu2O on the {101} Facets of TiO2 Nanosheet Arrays and Their Enhanced Photoelectrochemical Performance

Photoelectrochemical Properties of Ag/TiO2 Electrodes Constructed Using Vertically Oriented Two-Dimensional TiO2 Nanosheet Array Films

Nanocomposites of Carbon Nanotube/Polyaniline with Pending Calix[8]Arene and Their External Stimuli Response Properties

Carbon nanowires promoted Cu2O/TiO2 nanocomposite for enhanced photoelectrochemical performance

Photoelectrochemical properties of Mutil-Walled Carbon Nanotube/TiO2 nanocomposite films

Distinct visible-light response of composite films with CdS electrodeposited on TiO2 nanorod and nanotube arrays

Enhanced Photoelectrochemical Response of a Composite Titania Thin Film with Single-Crystalline Rutile Nanorods Embedded in Anatase Aggregates

Synthesis of g-C3N4/Bi2O3/TiO2 composite nanotubes: enhanced activity under visible light irradiation and improved photoelectrochemical activity

Synthesis of Co3O4/Ag/TiO2 Nanotubes Arrays Via Photo-Deposition of Ag and Modification of Co3O4 (311) for Enhancement of Visible-Light Photoelectrochemical Performance

Highly Enhanced Photoelectrocatalytic Properties by Α-Fe 2 O 3 Modified NF-TiO 2 Pyramids with Dominant (101) Facets

Composite of TiO2 Nanoparticles and Carbon Nanotubes Loaded on Poly(methyl Methacrylate) Nanofibers: Preparation and Photocatalytic Performance

Photoconductivity Study of Modified Carbon Nanotube/Oxotitanium Phthalocyanine Composites

Fabrication and characterization of photoelectrocatalytic electrodes of carbon nanotube/titanium oxide

High Photoconductive Nanocomposite Film Based on TiO 2 Nanotube Arrays and Copper Phthalocyanine

Large area photoelectrodes based on hybrids of CNT fibres and ALD grown TiO2

Characterization of CNT/TiO2Electrode Prepared Through Impregnation with TNB and Their Photoelectrocatalytic Properties

Photoconductivity Study of Modified Single-Wall Carbon Nanotube/ Oxotitanium Phthalocyanine