Abstract:A composite titania thin film consisted of quasi-aligned single-crystalline rutile nanorods embedded in sol-gel-derived anatase aggregates was fabricated and its photoelectrochemical behavior was studied in detail. A monolayer of nearly sing I e-crystal line rutile nanorods was first deposited on metallic Ti substrates through a controlled reaction between Ti and hydrogen peroxide. The gaps among the rutile nanorods were then filled with titania nanoparticles through a sol-gel dip-coating approach, which achieved a composite thin film of single-crystalline rutile nanorods embedded in anatase aggregates, after a subsequent thermal treatment at 723 K. The X-ray diffraction measurement revealed that the composite film with thickness of 180 nm contained anatase and rutile in a nearly 50:50 ratio. The UV-visible diffusive reflectance spectra estimated a band gap of 2.99 eV for the rutile monolayer and a slightly increased value of 3.03 eV for the composite film due to the embedding of the anatase nanoparticles. Photocurrent versus potential diagrams, photocurrent transient curves, and open-circuit potential measurement supported the fact that the anatase nanoparticles possessed better inherent photoelectrochemical properties than rutile. However, electrochemical impedance spectra characterization, together with photocurrent transient curves and open-circuit potential measurement, suggests that the single-crystalline rutile nanorods exhibited a higher electron-transfer rate. The combination of the two components in such an appropriate way enhanced significantly the charge separation effect arising from the anatase/rutile couple, which hence combined efficiently the "mixed crystal effect" and the "mixed morphological effect". A steady-state photocurrent more than double the simple sum of those generated by the two components alone was detected for the current composite film, which can be attributed to the single-crystalline rutile nanorods that provide channels for rapid electron transfer to the conductive Ti substrates under an applied bias potential. As a result, this study concludes that the present nanostructure magnified significantly the well-established mixed crystal effect, that is, an enhanced charge separation arising from a mixture of anatase and rutile.

Distinct visible-light response of composite films with CdS electrodeposited on TiO2 nanorod and nanotube arrays

Highly-enhanced Performance of TiO 2 Nanotubes Attached with CdS quantum Dots

Enhanced Visible-Light-Induced Photoelectrocatalytic Degradation of Methyl Orange by Cds Sensitized Tio2 Nanotube Arrays Electrode

Enhanced photoelectronic properties of single crystal TiO2 nanosheet array films by selective deposition of CdS nanoparticles on their {101} facets

Enhanced charge collection and photocatalysis performance of CdS and PbS nanoclusters co-sensitized TiO 2 porous film

Synthesis of Mesoporous CdS/titania Composites with Visible Light Photocatalytic Activities

Capability of Coupled CdSe/TiO2 Heterogeneous Structure for Photocatalytic Degradation and Photoconductivity

Hybrid Nanocomposite with Visible–light Photocatalytic Activity: CdS–pillared Titanate

Capability of coupled CdSe/TiO2 heterogeneous structure for photocatalytic degradation and photoconductivity.

Nanotube Film for Quantum Dots Sensitized Solar Cells

Translucent TiO2 Nanotube Film for Quantum Dots Sensitized Solar Cells

One-Step Fabrication of Cds Nanoparticle-Sensitized Tio2 Nanotube Arrays Via Electrodeposition

Enhanced Photoelectrochemical Response of a Composite Titania Thin Film with Single-Crystalline Rutile Nanorods Embedded in Anatase Aggregates

Optimization of Cds/Tio2 Nanotube-Array Composite Photocatalysts Prepared by Electrodeposition

Single-crystal Heterostructured PbTiO3/CdS Nanorods with Enhanced Visible-Light-driven Photocatalytic Performance

Fabrication and Photoelectrochemical Performance of CdS Quantum Dots Sensitized TiO2 Film Electrodes

Enhanced photoelectrochemical performance by synthesizing CdS decorated reduced TiO2 nanotube arrays

A novel approach to titania nanowire arrays as photoanodes of back-illuminated dye-sensitized solar cells

Synthesis of Co3O4/Ag/TiO2 Nanotubes Arrays Via Photo-Deposition of Ag and Modification of Co3O4 (311) for Enhancement of Visible-Light Photoelectrochemical Performance

Photoelectric Performance of Tio2 Nanotube Array Photoelectrodes Cosensitized with Cds/Cdse Quantum Dots

Assembly and Photoelectrochemical Studies of TiO2/CdS Nanocomposite Film