Abstract:Phase relations in the system MgSiO3-Al2O3 were investigated at pressures of 27-45GPa and temperatures of 1700, 2000, and 2300K using sintered diamond and tungsten carbide anvils in a multianvil apparatus. The bulk compositions in the MgSiO3-Al2O3 binary system crystallize a phase assemblage of pyrope and corundum at pressures below 27GPa and an assemblage of bridgmanite and corundum at pressures above 27GPa regardless of temperatures. The solubility of Al2O3 in bridgmanite and that of MgSiO3 in corundum increases significantly with increasing temperature. The solubility of Al2O3 in bridgmanite increases from 6.7mol% at 1700K to 21.8mol% at 2500K under a constant pressure of 27GPa. Bridgmanite becomes more aluminous with increasing pressure from 27 to 45GPa at a given temperature. The MgSiO3 content in corundum increases with increasing pressure at pressure lower than 27GPa, while it decreases at pressure higher than 27GPa. Our results suggest that bridgmanite can incorporate a considerably higher Al2O3 content than that of the pyrope composition (25mol% Al2O3). The present study further suggests that the entire Al2O3 component is accommodated into bridgmanite in the pyrolite lower mantle. However, Al2O3 cannot be fully accommodated into bridgmanite in the coldest parts of subducted slabs in the shallow part of the lower mantle, and therefore, additional phases such as MgAl2O4 with calcium ferrite-type structure are necessary to host the excess Al2O3.Plain Language Summary Here we determined the phase relations in the system MgSiO3-Al2O3 up to 2300K under lower mantle pressures and found that the solubility of Al2O3 in bridgmanite and that of MgSiO3 in corundum increase with increasing temperature. All Al2O3 can be completely accommodated into bridgmanite in the pyrolite composition, while the Al2O3 cannot be fully accommodated into bridgmanite in the coldest parts of subducted slabs, and therefore, additional phases are required to host the excess Al2O3.

Residual bond structure analysis of equilibrium phase diagram of Al-Si and Mg-Al alloys under pressure condition

EXPERIMENTAL STUDY ON THE PHASE RELATIONS OF THE SYSTEM Mg2SiO4-MgAl2O4 AT HIGH PRESSURE AND HIGH TEMPERATURE

Phase Relations in the System MgSiO3‐Al2O3 Up to 2300 K at Lower Mantle Pressures

Calculation Based on the Formation of Mg2Si and Its Effect on the Microstructure and Properties of Al–Si Alloys

EET Research on Melt Structural Information of Magnesium Alloy

Interphase Boundary Segregation Induced Phase Transformation in a High-Pressure Die Casting Mg-Al-La-Ca-Mn Alloy

First-principle Studies on the Mechanical, Thermodynamic and Electronic Properties of Β″-Mg3gd and Β′-Mg7gd Alloys under Pressure

Theoretical insights into the crystal and fundamental properties of MgAl9Zn compound: First-Principles calculations

A Phase Field Model Coupled with Pressure-Effect-embedded Thermodynamic Modeling for Describing Microstructure and Microsegregation in Pressurized Solidification of a Ternary Magnesium Alloy

Formation of Phases and Microstructures in Al-8Si Alloys with Different Mg Content

Study on Dendritic Growth in Pressurized Solidification of Mg–Al Alloy Using Phase Field Simulation

Deformation behavior and phase transformation of a dual-phase Mg−8.9Li−2.7Al-0.85Si alloy under compression test at elevated temperatures

Theoretical Investigation on Structural and Thermodynamic Properties of the Intermetallic Compound in Mg–Zn–Ag Alloy under High Pressure and High Temperature

Experimental Investigation and Thermodynamic Verification for the Phase Relation around the ε-Mg23 (Al, Zn)30 Intermetallic Compound in the Mg-Zn-Al System

Phase Field Simulation on Dendritic Growth in Pressurized Solidification of Mg-Al Alloy

Effect of the Al–Si eutectic on the microstructure and corrosion behavior of the single-phase Mg alloy Mg–4Li

Structural Evolution, Mechanical Properties, and Electronic Structure of Al–Mg–Si Compounds from First Principles

Establishment of nucleation model and microstructure simulation of Al-Si alloy for low pressure die casting

Structure and Property of Metal Melt I: the Number of Residual Bonds after Solid-Liquid Phase Changes

Atomistic determination on stability, cluster and microstructures in terms of crystallographic and thermo-kinetic integration of Al−Mg−Si alloys

First-principles Investigations of the Pressure-Induced Structural Transitions in Mg(AlH4)2