Abstract:To develop a new type of three-dimensional (3D) isolator proposed by authors and investigate seismic responses and 3D isolation effect of 3D isolated continuous girder bridges under different seismic intensities and characteristics,a 1/25 scaled three-span continuous girder bridge with 3D isolator bearing (3DIB) and a single-span girder bridge with the common natural rubber bearing (NRB) only for horizontal isolation were designed and manufactured.The 3DIB and NRB were designed and selected for the bridge model test.On this basis,the horizontal and vertical seismic simulation shaking table tests were respectively carried out on the three-span and single-span isolated continuous girder bridge models.The results show that the developed 3D isolation bearing takes effect safely and effectively with no damage under almost all seismic excitations after the test.There is no damage on three-dimensional isolation bearing after the test.Under the horizontal earthquake action,both 3DIB and NRB reveal favorable horizontal isolation effect with 50 ％-80％ for horizontal acceleration of main girders.The horizontal isolation effect of 3DIB with lead-core laminated rubber component is obviously better than that of NRB under near-fault pulse-like ground motions.Under the vertical seismic action,the peak vertical acceleration of the single-span girder isolated by NRB may obviously increase.The maximum acceleration may be double that of the original one.The amplitude may be enlarged in some time although the peak value is not amplified in some excitations.The peak vertical acceleration of the continuous girder with 3DIB will decrease by 30％,even up to 50％,and there is basically no local amplification in some time.The 3D isolated bridge shows satisfactory isolation effect under horizontal and vertical seismic excitations,which provides the valuable basis for 3D isolation technology applied in the bridge engineering.

Study on the Isolated Effect of the TianJing Yongding New River Bridge

A Method for Controlling Seismic Damage of RC Bridge Piers Subjected to Strong Aftershocks

Earthquake response of bridges bearing on flexible rubber considering pounding of girders

Lead-rubber-bearing with negative stiffness springs (LRB-NS) for base-isolation seismic design of resilient bridges: A theoretical feasibility study

Seismic Vulnerability Analysis of Concrete-Filled Steel Tube Tied Arch Bridges Using Symmetrically Arranged High-Damping Rubber Bearings

Analysis Of Longitudinal Seismic Response Of Bridge With Magneto-Rheological Elastomeric Bearings

Study of Dynamic Behavior and Influences Induced by Structural Parameter Variations of Self-Anchored Suspension Bridge

Study on the damping efficiency of continuous beam bridge with constant cross-section applied by lead rubber bearings and fluid viscous dampers

Isolation Effectiveness of Lead Rubber Bearing on Low-Medium-speed Maglev Vehicle-Bridge System under Earthquake

Seismic Response of Isolated Bridges with LRB under Muldi-Directional Earthquake-Part (Ⅰ) Shaking Table Test of Bridge Model

Study on vibration reduction and base isolation of continuous bridges

Behavior of high damping seismic isolation rubber bearings for bridges

Yielding Steel Dampers as Restraining Devices to Control Seismic Sliding of Laminated Rubber Bearings for Highway Bridges: Analytical and Experimental Study

Performance-Based Seismic Design of Hybrid Isolation Systems with Gap-Tunable BRBs for Bearing-Supported Bridges

SEISMIC RESPONSE OF ISOLATED BRIDGES WITH LRB UNDER MULDI-DIRECTIONAL EARTHQUAKE——PART (Ⅱ) THEORETICAL AND COMPARATIVE ANALYSIS

Shaking table test of isolated continuous girder bridge model under different earthquake intensity excitation

A study of the concrete continuous girder bridge shaking table test considering the sliding of laminated rubber bearings

Seismic Performance Of A Multi-Span Rc Highway Bridge With High Damping Rubber Bearings

Seismic performance assessment and design procedure of base-isolated bridges with lead-rubber-bearing and negative stiffness springs (LRB-NS)

Shaking Table Tests on Seismic Simulation of Three-dimensional Isolated Continuous Girder Bridges

Mechanical Behavior of Laminated Rubber Isolation Bearing with Buckling Steel Plate