Abstract:This process modelling study explored the behaviour of hydrogen-based direct reduced iron (DRI) manufacturing in a shaft furnace. Various performance parameters such as metallisation ratio (MR), consumption of hydrogen per tonne of DRI, production of by-products, reactor energy demand and total energy demands for the process have been analysed with respect to temperature, ore grade (gangue content), and reactant conditions. The HSC Chemistry (H: enthalpy, S: entropy and C: heat capacity) SIM (simulation) module was employed for the modelling coupled with the Gibbs energy minimisation calculation. The shaft furnace was divided into three zones to model the three-step reduction of iron ore in a counterflow arrangement. Results show that temperature and hydrogen supply have a significant effect on the metallisation of DRI. Increasing temperature and hydrogen flow rate were predicted to increase the MR or reducibility. A full metallisation can be achieved with hydrogen supply of 130, 110, 100 and 90 kg/tDRI at 700, 800, 900 and 1000°C, respectively, using the best-grade ore (Fe 69 wt.%, gangue 5.2 wt.%). However, the hydrogen consumption in full metallisation was calculated to be 54 kg/tDRI (tonne of DRI). At full MR, the reactor energy consumption (supplementary electrical energy) was calculated to be 0.56 to 0.59 MWh/t Fe feed using the reactor temperature from 700 to 1000°C. Ore grade or gangue content has a significant impact on reactor energy demand. For example, at 900°C, the top-grade ore was calculated to consume 0.69 MWh/tDRI compared to 0.88 MWh/tDRI using the lowest grade ore. A certain percentage of CO (i.e. 15%) blended with hydrogen was predicted to be beneficial for metallisation, hydrogen consumption, and overall energy demand. However, increasing CO would increase CO 2 emissions significantly.

Application of Entrained-Bed Pulverized Coal Gasification in Direct Reduction Iron-Making

Examination of Industrial Demonstration Unit of Coal Gasification for Pulverized Coal with Ash Agglomeration Technique

Fundamental Study on Utilization of Titanium Resources by RHF Process

A Review on the Modeling of Direct Reduction of Iron Oxides in Gas‐Based Shaft Furnaces

Development and Application of Hydrogen-Based Direct Reduction Iron Process

Direct reduction of iron to facilitate net zero emissions in the steel industry: A review of research progress at different scales

Effect of Carbon Addition on Direct Reduction Behavior of Low Quality Magnetite Ore by Reducing Gas Atmosphere

Reduction of Iron‐Ore Pellets Using Different Gas Mixtures and Temperatures

The Behavior of Direct Reduced Iron in the Electric Arc Furnace Hotspot

Direct reduction of iron-ore with hydrogen in fluidized beds: A coarse-grained CFD-DEM-IBM study

Cost and Life Cycle Analysis for Deep CO2 Emissions Reduction for Steel Making: Direct Reduced Iron Technologies

Toward environmentally friendly direct reduced iron production: A novel route of comprehensive utilization of blast furnace dust and electric arc furnace dust

Computational Study of Hot Gas Injection (HGI) into an Ironmaking Blast Furnace (BF)

Preparation of Direct Reduction Sponge Iron (DRI) Using Pyrite Cinder Containing Nonferrous Metals

Advanced physical model of hydrothermic reduction of iron ore pellets by dissociated 2H+ ionic gas in the shaft furnace

Direct reduction roasting-magnetic separation technique of a refractory iron ore

Thermodynamic analysis and experimental verification of the direct reduction of iron ores with hydrogen at elevated temperature

Process modelling for the production of hydrogen-based direct reduced iron in shaft furnaces using different ore grades

Hydrogen-based direct reduction of iron oxide at 700°C: Heterogeneity at pellet and microstructure scales

System development and thermodynamic performance analysis of a system integrating supercritical water gasification of black liquor with direct-reduced iron process

A Numerical Study of the Thermochemical and Aerodynamic States of H2‐intensive Direct Reduction Shaft Furnace