Abstract:A general model for hydrogen adsorption is derived to discuss the compressibility of the hydrogen molecules on the adsorption surface caused by the strong adsorptive potential exerted by the carbon wall. The mono-layer capacity (see Table 1) inside the tube of the MWCNTs tested in our laboratory is evalued by the comparison studies on the adsorptive performance between the tubular pore and the slit-pore, the results show that better adsorptive performance can only be obtained when temperature is getting lower or the diameter of the tube is getting smaller(see Fig. 1). From the model, the strong attraction to the surface may even cause hydrogen molecules to attain much higher densities than that of liquid hydrogen, and this will surely make adsorbed hydrogen molecules to behave as repulsion among each other. This phenomenon is discussed in terms of experimental data and the ascertained model (see Fig. 3). A linear form of the model is applied to determine the interaction energy between hydrogen molecules in the adsorbed layer from the experimental data. Analysis of the experimental data of hydrogen adsorption over a wide range of pressure and temperature shows that the energies of hydrogen-hydrogen interactions in the adsorbed phase are positive in low temperature region( < 200 K) and obtain the highest value in the temperature range of 160 similar to 180 K, but will be negative when the temperature is above 230 K(see Fig. 4), indicating the repulsions among the adsorbed hydrogen molecules are prominent in low temperature, however, the attractions among the adsorbed hydrogen molecules at higher temperature are hard to understand because the pressures are also high in those cases. Comments are made that the chemical adsorption should be included to interpret the experimental data at higher temperatures. The results presented here also show that the concept of 'maximum capacity' for hydrogen adsorption should differ from the density of the adsorbed hydrogen molecules.

Influence of Sample Cell Physisorption on Measurements of Hydrogen Storage of Carbon Materials Using a Sieverts Apparatus

Hydrogen Adsorption of Open-Tipped Insufficiently Graphitized Multiwalled Carbon Nanotubes

Measuring Hydrogen Storage Capacity of Carbon Nanotubes by High-Pressure Microbalance

The mechanism of hydrogen storage in carbon materials

Pore Size Effects of Nanoporous Carbons with Ultra-High Surface Area on High-Pressure Hydrogen Storage

Theoretical Studies on Hydrogen Adsorption of Single-Walled Boron-Nitride and Carbon Nanotubes Using Grand Canonical Monte Carlo Method

Effects of structure and surface properties on carbon nanotubes’ hydrogen storage characteristics

Performance Characterization and Comparison Study of Silver Molecular Sieve Hydrogen Adsorbents in Liquid Hydrogen Vessels

Hydrogen Absorption/desorption Properties of Li–Al–N–H Composite

The performance analysis of hydrogen adsorption storage in carbon nanofibres

Screening Study of Different Carbon-Based Materials for Hydrogen Storage

HYDROGEN ADSORPTION STORAGE STUDY ON MULTI-WALLED CARBON NANOTUBES

Grand Canonical Monte Carlo Simulation of Hydrogen Adsorption in Different Carbon Nano Structures

Comparative study of hydrogen storage properties of double-walled carbon nanotubes and well-aligned carbon nanotubes

Measuring Hydrogen Storage Capacity of Carbon Nanotubes by Tangent-Mass Method

Binding Energies and Electronic Properties of Hydrogen Adsorptions on 4-Angstrom Carbon Nanotubes

Study of H2 Physical Adsorption in Single-Walled Carbon Nanotube Array

Temperature dependent behavior of hydrogen molecules on carbon nanostructures

Influence of Different Cone Angles for Hydrogen Adsorption of Cup-Stacked Carbon Nanotube: A DFT Study

Theoretical Study on the Adsorbed Hydrogen Molecules on Multi-Walled Carbon Nanotubes

Abstract Submitted for the MAR07 Meeting of The American Physical Society Temperature and Pressure Dependence of Hydrogen Coverage on Single-Walled Carbon Nanotubes1