Abstract:A general model for hydrogen adsorption is derived to discuss the compressibility of the hydrogen molecules on the adsorption surface caused by the strong adsorptive potential exerted by the carbon wall. The mono-layer capacity (see Table 1) inside the tube of the MWCNTs tested in our laboratory is evalued by the comparison studies on the adsorptive performance between the tubular pore and the slit-pore, the results show that better adsorptive performance can only be obtained when temperature is getting lower or the diameter of the tube is getting smaller(see Fig. 1). From the model, the strong attraction to the surface may even cause hydrogen molecules to attain much higher densities than that of liquid hydrogen, and this will surely make adsorbed hydrogen molecules to behave as repulsion among each other. This phenomenon is discussed in terms of experimental data and the ascertained model (see Fig. 3). A linear form of the model is applied to determine the interaction energy between hydrogen molecules in the adsorbed layer from the experimental data. Analysis of the experimental data of hydrogen adsorption over a wide range of pressure and temperature shows that the energies of hydrogen-hydrogen interactions in the adsorbed phase are positive in low temperature region( < 200 K) and obtain the highest value in the temperature range of 160 similar to 180 K, but will be negative when the temperature is above 230 K(see Fig. 4), indicating the repulsions among the adsorbed hydrogen molecules are prominent in low temperature, however, the attractions among the adsorbed hydrogen molecules at higher temperature are hard to understand because the pressures are also high in those cases. Comments are made that the chemical adsorption should be included to interpret the experimental data at higher temperatures. The results presented here also show that the concept of 'maximum capacity' for hydrogen adsorption should differ from the density of the adsorbed hydrogen molecules.

Measuring Hydrogen Storage Capacity of Carbon Nanotubes by Tangent-Mass Method

Measuring Hydrogen Storage Capacity of Carbon Nanotubes by High-Pressure Microbalance

Hydrogen Storage in Multi-Wall Carbon Nanotubes Using Samples Up to 85 G

Hydrogen Adsorption of Open-Tipped Insufficiently Graphitized Multiwalled Carbon Nanotubes

Comparative study of hydrogen storage properties of double-walled carbon nanotubes and well-aligned carbon nanotubes

HYDROGEN ADSORPTION STORAGE STUDY ON MULTI-WALLED CARBON NANOTUBES

INVESTIGATION FOR HYDROGEN-STORAGE MECHANISM OF SINGLE-WALL NANOTUBE

Mechanics of Hydrogen Storage in Carbon Nanotubes

Simulation Study of Hydrogen Storage in Single Walled Carbon Nanotubes

Hydrogen storage in BC_3 composite single-walled nanotube:a combined density functional theory and Monte Carlo investigation

Pore Structure And Hydrogen Storage Of Carbon Nanotubes

Hydrogen uptake in multi walled carbon nanotubes at room temperature

Hydrogen Storage in Carbon Nanotubes Through the Formation of Stable C-H Bonds.

CARBON NANOTUBES GROWING OVER NATURAL MINERALS AND PRELIMINARY STUDY ON THEIR CAPABILITY OF HYDROGEN STORAGE

THE EFFECT OF SURFACE TREATMENTS ON HYDROGEN STORAGE OF CARBON NANOTUBES

Hydrogen Storage Behavior of Amorphous Carbon Nanotubes at Low Pressure and Room Temperature

Can hydrogen be stored inside carbon nanotubes under pressure in gigapascal range?

The Grand Canonical Monte Carlo Simulation of Hydrogen Physisorption on Single-Walled Carbon Nanotubes at the Low and Normal Temperatures

Studies of Multi-walled Carbon Nanotubes and Their Capabilities of Hydrogen Adsorption

Effects of structure and surface properties on carbon nanotubes’ hydrogen storage characteristics

Theoretical Study on the Adsorbed Hydrogen Molecules on Multi-Walled Carbon Nanotubes