Abstract:This work describes the fabrication of TiO2 nanotube array membranes with uniform tube size distribution by anodization of titanium flat sheets in ethylene glycol with 0.55%NH4F+1.0%H2O and with 0.25%NH4F+2.0%H2O(volume fraction). The membranes were investigated for characteristics such as tube size, thickness by varying applied voltage and ammonium fluoride concentration of electrolyte. Morphology of the membranes was examined using scanning electron microscopy. Results showed that flat sheet membranes having wide tube size and uniform tube distribution with parallel channel arrays were obtained. The tube sizes(inner) ranged from 15 to 128 nm and the wall thicknesses was as high as 360 mu m. It was found that the tube size increased in direct proportion with the applied voltage, and the tube size little decreased with the ammonium fluoride concentration increasing. It was also observed that increase in ammonium fluoride concentration remarkably increased tubular membrane thickness. With anhydrous ethanol cleaning repeately rinsed membranes, then using absorbent cotton made membranes quickly dried and thermal treatment its in an air environment at 100 degrees C for and heat treatment at 100 degrees C for 1 h effectually solved the problem of membrane curl. By anodic titania technology, robust ceramic tubes with uniformly distributed tube structure and parallel nanochannels of lengths and sizes practical for industrial applications were reliably produced in quantity.

Fabrication of TiO2 Nanotube Arrays by a Two-Step Anodic Oxidation

Fabrication of TiO2 Nanotube Arrays by Electrochemical Anodization in an NH4F/H3PO4 Electrolyte

Preparation and Characterization of TiO<SUB>2</SUB> Nanotube Arrays by Anodic Oxidation Method: Preparation and Characterization of TiO<SUB>2</SUB> Nanotube Arrays by Anodic Oxidation Method

Fabrication of TiO2 Nanotube Arrays via Electrochemical Anodization in NH4F/H3PO4 Electrolyte Solution System

Preparation of TiO2 Nanotube Arrays by Anodic Oxidation

Fabrication of highly ordered TiO2 nanotube arrays via anodization of Ti-6Al-4V alloy sheet.

Preparation of TiO_2 Nanotube Arrays and Their Photoelectrochemical Properties

Preparation Of Tio2 Nanotube Arrays And Their Photoeleetrochemical Properties

Effect of Two-Step Anodization on Structure of TiO2 Nanotube Arrays

Fabrication and Properties of Tio2 Nanotube Arrays Using Glycerol-Dmso-H2o Electrolyte

Controllable Preparation of TiO2 Nanotube Arrays on Ti Foil Substrates

Fabrication of TiO<sub>2</sub> Nanotube Arrays in Ethylene Glycol Electrolyte by the Electrochemical Anodization Method

TiO2 nanotube arrays prepared by anodic oxidation method

Study on preparation of TiO_2 nanotube arrays by anodizing processes

Fabrication of Titanium Oxide Nanotube Arrays by Anodic Oxidation

Fabrication and Microstructure of TiO2 Nanotube Arrays Membranes

Morphology of TiO_2 Nanotube Arrays Prepared by Anodic Oxidation

Electrochemical Fabrication and Formation Mechanism of Tio2 Nanotube Arrays on Metallic Titanium Surface

Fabrication and formation mechanism of self-organized TiO2 nanotube arrays

Titanium oxide nanotube arrays prepared by anodic oxidation

Synthesis of TiO<sub>2</sub> Nanotube Arrays Through Multistep Anodization