Abstract:Abstract In pure heat transfer, specifications of effectiveness, fluid properties, and flows enable calculation of the heat exchanger area. In the case of falling film absorption, a simultaneous heat and mass transfer governs the performance of the absorber. The exchange of mass across the liquid-vapor interface involves the generation of heat. The heat effects associated with the mass exchange increase the temperature, which affects the equilibrium state of the pressure and composition and in turn affects the mass. The falling film flow rate coupled to the physical properties of kinematic viscosity and surface tension govern the flow regime of a vertical falling film. Wavy-laminar, roll-wave laminar, and turbulent flows will develop convective contributions that can enhance the transfer of mass into the film. The combined interaction of all these factors makes the absorption process very difficult to analyze and predict. A study of simultaneous heat and mass transfer was therefore conducted on a vertical falling film absorber to better understand the mechanisms driving the heat and mass transfer processes. Falling films are characteristically unstable, and a wavy-laminar flow was observed during the experimental study. The wavy flow further complicates the problem; therefore, only limited information is known about the temperature and concentration profiles along the length of the absorber that describe the local heat and mass transfer rates. Hence, this study presents much-needed experimental data on the heat and mass transfer processes in the absence of heat and mass transfer additive. Absorption experiments were conducted in a mini-absorber test stand at various falling film flow rates, at various absorber pressures, and with various compositions of the binary salt solution. Thermographic phosphors were successfully used to measure the temperature profile along the length of the absorber test tube. These measures of the local variations in temperature enabled calculation of the bulk concentration along the length of the absorber. The bulk concentration varied linearly, from which one may infer that the concentration gradient in the direction of flow is approximately constant. The implication is that the mass flux, and therefore the absorber load, can be solved for by using a constant flux approximation.

Mass Transfer Study of Ammonia-water Falling-film Absorption in Vertical Tube

Coupled Heat and Mass Transfer Analysis of NH 3 -H 2 O Falling Film Absorption on Inner Tube Surface with Low Solution Flow Rates

Experimental Study of Heat and Mass Transfer for Ammonia-Water Falling Film Absorption on Novel S-shaped Capillary Tubes Bundle

Numerical Analysis of the Enhancement of Ammonia-Water Falling Film Absorption Process by Atomized Equipment

Evaluation Method and Experimental Performance of Inner Vertical Adiabatic Falling Film Absorption

Experimental study on absorption characteristics of a falling film absorber with micro-scale NH<sub>3</sub>/LiNO<sub>3</sub> liquid film

Numerical investigation of ammonia falling film absorption outside vertical tube with nanofluids

A Heat Transfer Model of Ammonia Horizontal Falling-film Absorption

Experimental study on heat and mass transfer performance of falling film absorption over a vertical tube using LiCl solution

Experimental and Simulated Study on Mass and Heat Transfer of Falling Film Evaporator for Ammonia-Containing Wastewater

Experimental Study on Heat and Mass Transfer in Falling Film Absorption of Aqueous Lithium Chloride.

Study On Heat And Mass Transfer Of Adsorbent Beds In Adsorption Refrigeration System

Numerical Analysis of Multistage Ultrasonic Atomization Enhanced Ammonia-Water Falling Film Absorption

Study on the Heat-mass Transfer in Falling Film Outside the Vertical Tube for Water Vapor Absorption into Aqueous Lithium Bromide

STUDY ON HEAT AND MASS TRANSFER OF AN AIR COOLED VERTICAL FALLING LIQUID FILM ABSORPTION

Experimental Study of Forced Convective Mass Transfer in Horizontal Tube Falling Film Evaporation

Experimental Investigation Of Heat And Mass Transfer Of Failing Film Absorption In A Vacillating Tube With Tfe/Nmp Solution

The Experimental Analysis of Local Heat and Mass Transfer Data for Vertical Falling Film Absorption

Study on the head and mass transfer of ammonia liquor under lower pressure and temperature

Investigation on Mass Transfer Characteristics of the Falling Film Absorption of LiBr Aqueous Solution Added with Nanoparticles

Simulation and Analysis of Characteristics of Distillation Column in Ammonia-water Absorption Refrigeration Systems