Abstract:Abstract In pure heat transfer, specifications of effectiveness, fluid properties, and flows enable calculation of the heat exchanger area. In the case of falling film absorption, a simultaneous heat and mass transfer governs the performance of the absorber. The exchange of mass across the liquid-vapor interface involves the generation of heat. The heat effects associated with the mass exchange increase the temperature, which affects the equilibrium state of the pressure and composition and in turn affects the mass. The falling film flow rate coupled to the physical properties of kinematic viscosity and surface tension govern the flow regime of a vertical falling film. Wavy-laminar, roll-wave laminar, and turbulent flows will develop convective contributions that can enhance the transfer of mass into the film. The combined interaction of all these factors makes the absorption process very difficult to analyze and predict. A study of simultaneous heat and mass transfer was therefore conducted on a vertical falling film absorber to better understand the mechanisms driving the heat and mass transfer processes. Falling films are characteristically unstable, and a wavy-laminar flow was observed during the experimental study. The wavy flow further complicates the problem; therefore, only limited information is known about the temperature and concentration profiles along the length of the absorber that describe the local heat and mass transfer rates. Hence, this study presents much-needed experimental data on the heat and mass transfer processes in the absence of heat and mass transfer additive. Absorption experiments were conducted in a mini-absorber test stand at various falling film flow rates, at various absorber pressures, and with various compositions of the binary salt solution. Thermographic phosphors were successfully used to measure the temperature profile along the length of the absorber test tube. These measures of the local variations in temperature enabled calculation of the bulk concentration along the length of the absorber. The bulk concentration varied linearly, from which one may infer that the concentration gradient in the direction of flow is approximately constant. The implication is that the mass flux, and therefore the absorber load, can be solved for by using a constant flux approximation.

Numerical Analysis of the Enhancement of Ammonia-Water Falling Film Absorption Process by Atomized Equipment

Parameters optimization of the parallel and series mode ultrasonic atomizer on the ammonia-water absorption system

Experimental Study on Carbon Dioxide Absorption by Aqueous Ammonia with Nickel and Chromium Ions in Bubbling Tower at Low Temperatures

Experimental and Simulated Study on Mass and Heat Transfer of Falling Film Evaporator for Ammonia-Containing Wastewater

Research progress of absorption characteristics enhancement of LiBr/NH_3-H_2O with additives and nano-particles

Three-Dimensional Simulation Of Effervescent Atomization Spray

EFFECTS OF LIQUID PROPERTIES ON DROP MEAN DIAMETER IN EFFERVESCENT ATOMIZATION SPRAY

A Novel Technique for Improving the Performance of Ammonia Absorption Refrigeration Cycle

Volumetric Overall Mass Transfer Coefficients of CO_2 Absorption Into Aqueous Ammonia of Fine Spray

Numerical Models For Viscoelastic Liquid Atomization Spray

Numerical simulation and spray model development of liquid ammonia injection under diesel-engine conditions

STUDY ON HEAT AND MASS TRANSFER OF AN AIR COOLED VERTICAL FALLING LIQUID FILM ABSORPTION

A microchannel shell-and-tube absorber for ammonia-water absorption

De-ammonification using direct contact membrane distillation – An experimental and simulation study

Experimental and Numerical Simulation Studies on the Atomization Characteristics of the Internal Mixing Nozzle and Its Field Application

Experimental parameter study and correlation development of microchannel membrane-based absorption process for efficient thermal cooling with high compactness

Numerical analysis of flash-boiling spray characteristics with liquid ammonia

Study on the ammonia-water two-stage evaporation absorption refrigeration system for the cooling process with temperature-distributed heat load

The Experimental Analysis of Local Heat and Mass Transfer Data for Vertical Falling Film Absorption

Development of a Novel Quasi-3D Model to Investigate the Performance of a Falling Film Dehumidifier with CFD Technology

Experimental study on the influence of adding TiO 2 nanoparticles on practical ammonia-water absorption refrigeration system-the generation and rectification processes