Abstract:Summary Accurate finite element (FE) models play an essential role in the health monitoring of operational bridges. Static structural deflections caused by vehicles, which are used in traditional finite element model updating (FEMU) methods, are often procured from field tests, interrupting the traffic and limiting the test loading scenarios. This study proposes a FEMU method that directly applies the massive, multi‐source structural and traffic data in the operation phase to update the FE model, effectively solving the defects above. We use the computer vision‐based vehicle load identification technique to accurately locate and weigh vehicle loads and carry out static simulations in the FE model based on the identified vehicle loads. The proposed FEMU objective function is established using indices including dynamic structural characteristics and vehicle‐induced static structural responses. The static error index in the objective function integrates the curve shape and extrema difference of theoretic and measured static responses. Finally, we deploy a parallel particle swarm optimization (PSO) algorithm to find the global optimal updated FE model. A continuous scale bridge model is employed in the experimental studies with four typical scenarios. Compared to the results from the initial FE model, the updated FE model provides significantly better results both in dynamic and static aspects in all scenarios, and the static error indexes reduce by 75% on average. The proposed method offers a practical approach to deploying the monitoring data for real‐time FEMU, which considers dynamic and static features and provides a basis for damage detection, performance assessment, and management.

Progressive finite element model calibration of a long-span suspension bridge based on ambient vibration and static measurements

Sensor Placement of Long-Term Health Monitoring for Large Bridges Based on the Real-Time Correction of Finite Element Model

Fe Model Updating Of Suspension Bridge Based On Vibration Measurements

Finite Element Model Updating and Validating of Runyang Suspension Bridge Based on SHMS

Structural-health-monitoring-oriented Baseline Finite Element Model of a Long-span Suspension Bridge

Finite Element Model Updating for the Runyang Cable-Stayed Bridge Tower Using Ambient Vibration Test Results

Estimation of Main Cable Tension Force of Suspension Bridges Based on Ambient Vibration Frequency Measurements

Dynamic Test and Finite Element Model Updating of Bridge Structures Based on Ambient Vibration

MULTI-PHASE FE MODEL UPDATING ON LONG-SPAN CABLE-SUPPORTED BRIDGES

Finite Element Model Updating of Bridge Structures Based on Sensitivity Analysis and Optimization Algorithm

SENSITIVITY-BASED FE MODEL UPDATING OF A SUSPENSION BRIDGE

Baseline finite element modeling of a large span cable-stayed bridge through field ambient vibration tests

Finite Element Modeling and Calibration of a Three-Span Continuous Suspension Bridge Based on Loop Adjustment and Temperature Correction

Finite Element Model Updating for a Cable-stayed Bridge Considering the Boundary Condition Constraint and Parameter Sensitivity

Investigation of FE Modeling Method for Tower Structure of Suspension Bridge 2.Model Updating and Verification

Updating of Dynamic Model for Long-Span Bridges Based on Structural Sensitivity Analysis and Optimization Design Principle

FINITE ELEMENT MODEL UPDATING FOR A RIGID FRAME-CONTINUOUS GIRDERS BRIDGE BASED ON RESPONSE SURFACE METHOD

Finite element model of a cable-stayed bridge updated with vibration measurements and its application to investigate the variation of modal frequencies in monitoring

Dynamic Characteristic Parameters Identification and Finite Element Model Updating for Continuous Rigid Frame Bridge

Static Finite Element Model Updating for Special-Shaped Bridge Based on Uniform Design Method

Finite element model updating method for continuous girder bridges using monitoring responses and traffic videos