Abstract:Creep behaviors of nanocrystalline (NC) Cu, Ni-20(wt.%)Fe and Ni with comparable grain sizes were examined by nanoindentation tests. It was showed that the creep behaviors depend on loading strain rate and stacking fault energy (SFE). At high loading strain rate, the initial creep rates of three NC materials are far higher than those predicted by the models of the Coble creep and the grain boundary sliding and are the highest and lowest for NC Cu and NC Ni, respectively, while that of NC Ni–20Fe lies between them due to their different SFE. At low loading strain rate, the creep behaviors do not exhibit significant difference among three NC materials. Our analysis revealed that grain boundary dislocation sources can be activated at high loading strain rate and the emitted dislocations from grain boundaries can be effectively stored in the loading regime, but cannot at low loading strain rate. The very high initial creep rates of three NC materials are attributed to the rapid absorptions of the stored dislocations in the loading regime and the newly nucleated dislocations in the holding regime. The higher creep rate of NC Cu as compared with those of NC Ni–20Fe and NC Ni arises from the higher density of the stored dislocations caused by the enhanced interactions of dislocations with twins and stacking faults due to its lower SFE.

Indentation Creep Behavior of Nano-Scale Ag/Co Multilayers

Nanoindentation Investigation of the Mechanical Behaviors of Nanoscale Ag/Cu Multilayers

Room Temperature Nanoindentation Creep of Nanoscale Ag/Fe Multilayers

Microstructure and Nanoindentation Investigation of Magnetron Sputtering Ag/Co Multilayers

Size dependence of creep behavior in nanoscale Cu/Co multilayer thin films

Investigation on Indentation Creep by Depth Sensing Indentation

Indentation Size Dependent Plastic Deformation of Nanocrystalline and Ultrafine Grain Cu Films at Nanoscale

Nanoindentation Creep Behavior of an Al0.3CoCrFeNi High-Entropy Alloy

Indentation size and loading strain rate dependent creep deformation of nanocrystalline Mo

Microstructure and mechanical properties of nanoscale Cu/Ni multilayers

The mechanisms of nanoindentation creep in Al thin metal films

An Investigation of Nanoindentation Creep in Polycrystalline Cu Thin Film

Time Dependent Plasticity At Real Nanoscale Deformation

Study on Indentation Creep Behavior of Single Crystal PdSi and Cr Thin Film

Nanoindentation Study of Amorphous-Co79zr13nb8/cr Multilayers

Revealing thickness dependence of hardness, strain rate sensitivity, and creep resistance of nano-crystalline magnesium/titanium multilayers by nanoindentation

Effects of Loading Strain Rate and Stacking Fault Energy on Nanoindentation Creep Behaviors of Nanocrystalline Cu, Ni-20 Wt.%fe and Ni

Thickness-Dependent Strain Rate Sensitivity of Nanolayers Via the Nanoindentation Technique

Investigation of Nanoindentation on Co/Mo Multilayers by the Continuous Stiffness Measurement Technique

Rate-dependent nanoindentation creep behavior of a Fe-based amorphous coating

Room temperature nanoindentation creep behavior of CoNiCrMo-based high entropy amorphous alloy coatings prepared by HVAF