Abstract:Using cobaloxime boron fluoride (COBF) and AIBN as catalyst and initiator respectively, the catalytic chain transfer bulk polymerization of 2-hydroxyporpyl methacrylate ( HPMA) was carried out at 60 degrees C and the low molecular weight polymer with a terminal double bond was prepared. The evolution of the apparent chain transfer constant (C-S(spp)) of COBF during the polymerization was determined by the Mayo equation and the CLD (chain length distribution) equation respectively. At the beginning of the reaction the chain transfer constant showed values of up to about 2000, but with the increasing of the monomer conversion, the chain transfer constant decreases and keeps at a value of about 600 for sometime and then decreased again. The most likely cause for the catalyst deactivation is the stable cobalt-carbon bond formed at the first period of the reaction and then reached equilibrium point. When the polymerization proceeds up to middle and high conversion, the chain transfer polymerization is further manipulated by diffusions of polymeric propagating chain and catalyst molecules, and the apparent chain transfer constant fell to value of below 300. It has been found also, that the data determined by the CLD equation are usually lower than those by the Mayo equation, especially at high conversion stage. It is because that both original equations are available for the instantaneous produced polymer or the case of very lower conversion stage. However, the GPC measurements give molecular weight distributions of the cumulated products rather than the instantaneous produced polymer. The number-average polymerization degrees for the instantaneous produced polymers were obtained from the GPC data, and used in the Mayo equation method together with the modification of the monomer concentration. It was believed that the apparent chain transfer constants from the modified Mayo equation method are more available for the middle and high conversion cases.

Control of Molecular Weight in Tetrahydrofuran Polymerization Initiated by Heteropolyacid

Effective promotion of tetrahydrofuran polymerization initiated with heteropolyacid

Tetrahydrofuran polymerization initiated by heteropolyacid in the presence of ethylene oxide: Reaction behavior of water and glycol

Polymerization of Tetrahydrofuran Initiated by Heteropolyacid in the Presence of Substituted Oxirane

Ethylene Oxide Promoted Polymerization of Tetrahydrofuran Initiated with Low Concentration of Heteropolyacid

Synthesis of Molecular Weight Controllable Bimodal Polyethylene from Fluorinated FI–Ti Catalyst Coupled with ZnEt2

TETRAHYDROFURAN POLYMERIZATION INITIATED\=WITH HETEROPOLYACID . REACTION BEHAVIOR OF ETHYLENE OXIDE

Synthesis of Ultrahigh-Molecular-weight Ethylene-1-hexene Copolymers with High Hexene Content Via Living Polymerization with Fluorinated Bis(phenoxy-Imine) Titanium(iv).

Studies on Mechanism of Tetrahydrofuran Polymerization Initiated by a Heteropolyacid

EFFECT OF ETHYLENE GLYCOL ON POLYMERIZATION OF TETRAHYDROFURAN AND MOLECULAR WEIGHT OF PRODUCT

Theoretical Study on the High Polymer Molecular Weight of Heteroatom-Substituted Constrained Geometry Catalyst

Macromol. Rapid Commun. 3/2015

Tetrahydrofuran Polymerization Initiated with Heteropolyacid Vi. Epichlorohydrin As Promoter

Control of Diffusion/Barrier Effects of Polymer-Coated Particles and the Strengthening of Ethylene Polymerization Reactor

Tetrahydrofuran polymerizatiion initiated with heteropolyacid IV. Propylene oxide as promoter

Tetrahydrofuran Polymerization Initiated with Heteropolyacid - V. Determination of Concentration of Propagating Species and Chain Propagation Rate Constant

Thermal and Mechanical Properties of Ultrahigh-Molecular-Weight Ethylene/1-Hexene Copolymers Prepared by Living Polymerization with Fluorinated Bis(Phenoxy-Imine) Titanium(Iv) Catalyst

THE EVOLUTION OF THE CHAIN TRANSFER CONSTANT DURING THE CATALYTIC CHAIN TRANSFER POLYMERIZATION OF 2-HYDROXYPROPYL METHACRYLATE

Preparation of Polyether Triol and Three-Armed Polyether Triol by Tetrahydrofuran Polymerization Initiated with Heteropolyacid

Tetrahydrofuran polymerization intiated by heteropolyacid VII. Oxetane as promoter

Dual Control of Stereoregularity and Molecular Weight in Cationic Polymerization of Vinyl Ether by Tunable TADDOLs/TiCl 4 Initiating Systems