Abstract:This study focuses on the properties of polyaniline (PANI) thin deposited onto glass substrates using a chemical bath method. The films were prepared under the same conditions, except for the type of oxidant used. Three oxidants were utilized: potassium per-sulfate (KPS), sodium per-iodate (NAIO 4 ), and ferric chloride di-hydrated (FeCl 3 ·2H 2 O). X-ray diffraction (XRD) analysis confirmed that all deposited films had an amorphous structure. Fourier-transform infrared spectroscopy (FT-IR) confirmed the presence of PANI films, as indicated by the recorded peaks. Scanning electron microscopy (SEM) was employed to study the surface structure and morphologies of the films, revealing nano-structured grains with varying average grain sizes depending on the oxidant type. The elemental composition of the films was analyzed using X-ray photoelectron spectroscopy (XPS). The optical band gap values were determined to be 4.06 eV, 3.93 eV, and 3.96 eV for FeCl 3 ·2H 2 O, NAIO 4 , and KPS oxidants, respectively. The refractive index and extinction coefficient were also calculated from optical data, showing significant variations with changes in the oxidant type. The high frequency dielectric constant of the films was estimated using the Spitzer-Fan model, resulting in values of 5.15, 3.24, and 474 for FeCl 3 , NAIO 4 , and KPS oxidants, respectively. Additionally, cyclic voltammetry studies revealed that PANI/glass films grown using NAIO4 exhibited the highest specific capacity. Further investigation of PANI/FTO/glass films showed a specific capacity estimated to be 100 Fg-1 for this particular film configuration.

Effect of solution concentration on the UV–vis spectroscopy measured oxidation state of polyaniline base

Effects of Acidity on the Size of Polyaniline-Poly(sodium 4-Styrenesulfonate) Composite Particles and the Stability of Corresponding Colloids in Water

Fabrication of one dimensional polyaniline nanofibers by UV-assisted polymerization in the aqueous phase.

Full View of Single-Molecule Force Spectroscopy of Polyaniline in Oxidized, Reduced, and Doped States.

Water-soluble polyaniline and its composite with poly(vinyl alcohol) for humidity sensing

In Situ Uv-Visible Absorption Spectrum Monitoring the Electrochemical Degradation of Pan Films

Investigation of 4,4'-bis(2-[l-styryl]-l-benzenesulfonoic) diacid doped polyaniline

Investigation of 4,4'-Bis(2-[1-styryl]-1-benzenesulfonoic Diacid Doped Polyaniline

Polyacetylene Nanoparticles-Based Preparation of Polyaniline Nanofibers

Effect of Ag+ on the Morphologies and Properties of Polyaniline

Raman Spectroscopic Studies on Electrosynthesized Polyaniline Film

Effect of toluene-4-sulfonic acid monohydrate concentrations on properties of polyaniline for pyrene detection via photoluminescence spectroscopy

Effects of Ultrasonic Irradiation on the Morphology of Chemically Prepared Polyaniline Nanofibers

Molecular Dynamics Simulation Study on the Structural and Thermodynamic Analysis of Oxidized and Unoxidized Forms of Polyaniline

Tailoring physical properties and electrochemical performance of polyaniline thin films via chemical bath deposition

Annealing Effects of Dilute Polyaniline/NMP Solution

Time-dependent Density Functional Theory Study on the Excited-State Hydrogen-Bonding Characteristics of Polyaniline in Aqueous Environment

Effect of solvent and co-solvents on the processibility of polyaniline: II. Spectriscopic and diffraction studies

Spectroscopic And Electrical Characterization Of Some Aniline Oligomers And Polyaniline

Study on Properties of Doped Polyaniline

An Analysis of Degradation and Stability of Polyaniline Doped with Three Common Industrial Acids