Abstract:In this paper, aluminium chloride crystal was used as precursor to prepare silica-alumina aerogel support by sol gel method, and the active component K2CO3 was supported on the aerogel support by incipient-wetness impregnation method to obtain a modified potassium-based adsorbent. CO2 adsorption experiment was performed on the adsorbent under different reaction conditions using a small fixed-bed reactor self designed. Based on the characterization results of low temperature N-2 adsorption-desorption experiments and scanning electron microscopy, CO2 adsorption characteristics of modified potassium-based adsorbents were studied. The prepared silica-alumina aerogel support has good microstructure and uniform pores with specific surface area and pore volume are 445.7517 m(2)/g and 2.3270 cm(3)/g, respectively, and the mesopores account for more than 99%. After loading, the active component K2CO3 is uniformly dispersed. Through model comparison, it was determined that the shrinking core model and Avrami fractional kinetic model were used to fit the experimental results in order to study the reaction kinetics and adsorption kinetics. The results show that as the temperature rises, the amount of CO2 adsorbed by the adsorbent increases first and then decreases. The increase in temperature can improve the activity of the active site of the adsorbent and make the reversible exothermic reaction occur while the adsorbent adsorbs CO2 cannot proceed in the forward direction at the same time. According to the kinetic analysis, the control period of the surface chemical reaction is too short due to the high temperature, which caused low carbonation conversion. The optimal designed loading of modified potassium-based adsorbent, reaction temperature, water vapor pretreatment time, CO2 concentration and total gas volume were 30%, 60 degrees C, 30 min, 12.5%, and 500 mL/min, respectively.

Chemical Modification of Activated Carbons

The Hydrophobisation of Activated Carbon Surfaces by Organic Functional Groups

Hierarchical Pore Structure of Activated Carbon Fabricated by CO2/microwave for Volatile Organic Compounds Adsorption

Surface Modification of Activated Carbon for Siloxane Adsorption

SURFACE MODIFICATIONS OF ACTIVATED CARBON AND ITS IMPACT ON APPLICATION

Chemical Modification And Adsorption Of The Pure Silica Mesoporous Molecular Sieve Kit-1

CO2 Adsorption on Modified Mesoporous Silicas: The Role of the Adsorption Sites

Activated Carbons from Co-Mingled Liquid

Synthesis and characterization of mesoporous and amorphous silica modified with silica-organo-sulfogroups

Chemical Reactions of Double Bonds in Activated Carbon: Microwave and Bromination Methods

Synthesis, characterization, and selective CO2 capture performance of a new type of activated carbon-geopolymer composite adsorbent

Activated carbon as catalyst support: precursors, preparation, modification and characterization

Thermogravimetric Analysis of Carbon Sorbents Modified by Ammonium Bromide

Experiment and Kinetic Model Study on Modified Potassium-Based CO2 Adsorbent

Enhancement of CO2 Adsorption on High Surface Area Activated Carbon Modified by N2, H2 and Ammonia

Modification of coal gasification slag-based activated coke by KOH activation method and its adsorption performance on methyl orange

CO2 adsorption on chemically modified activated carbon

Influence of Tectonically Deformed Coal-Based Activated Carbon and Its Surface Modification on Methane Adsorption

Carbon Dioxide Adsorption by a High-Surface-Area Activated Charcoal

SYNTHESIS, STRUCTURE AND PROPERTIES OF BENTONITE - ACTIVATED CARBON COMPOSITE

Unlocking the Potential of Chemically Modified Carbon Gels in Gallic Acid Adsorption