Abstract:In high temperature conditions, this can cause considerable changes in the mechanical properties of the composite. In order to determine the structural and mechanical property changes that occur in composite materials at elevated temperatures, to elucidate the damage mechanisms at elevated temperatures, and to improve the stability and durability of the materials. This paper studies how plasma treatment time affects the surface polarity, roughness, wettability and mechanical properties of carbon fibers. The results showed that the best wettability was attained after 10 min of plasma treatment, and new oxygen-containing functional groups (COO- and -C=O) developed on the fiber surface. The fundamental explanation is that during plasma surface treatment, the CH group in the bisphenol A part chain segment present in the epoxy resin sizing agent's composition is oxidized, forming an organic oxide layer. In this paper, the plasma modification technology was utilized to improve the interfacial compatibility of carbon fiber and Polyimide (PI) resin, and the interlaminar shear strength reached 103.98 MPa, up 10.49 %, and the strength retention rate was 84.3 % at 300 °C. In this paper, the plasma modification technique was employed to increase the interfacial compatibility of carbon fiber and PI resin. It was found that the Inductively Coupled Plasma (ICP) treated carbon fiber surfaces underwent physical and chemical changes that effectively enhanced the interfacial compatibility with the resin. However, the chemical groups and physically etched regions on the surface of the plasma-modified fibers are able to impede the relative motion of the resin to a certain extent, thus improving the interfacial strength.

Impact on water sorption and solubility of SY-1 facial elastomer treated with Argon plasma

Studies on the Affinity Membrane for Adsorption and Purification of Lysozyme(I) - Influence of Low-temperature Oxygen Plasma Treatment on Surface Structure and Adsorption Properties of the Affinity Membrane

Surface Potential Decay and DC Surface Flashover Characteristics of DBD Plasma-Treated Silicone Rubber

Surface Modification of Fluorosilicone Acrylate RGP Contact Lens Via Low-Temperature Argon Plasma

THE SURFACE TREATMENT OF POROUS POLYPROPYLENE MEMBRANE BY AR PLASMA WITH A LOW POWER

Plasma resistance of addition-cure liquid silicone rubber with Ureido-attached MQ silicone resin

Mechanisms of Surface Charge Dissipation of Silicone Rubber Enhanced by Dielectric Barrier Discharge Plasma Treatments

Plasma Treatment to Improve the Hydrophobicity of Contaminated Silicone Rubber — the Role of LMW Siloxanes

Hydrophilization of liquid surfaces by plasma treatment

The stability of radio-frequency plasma-treated polydimethylsiloxane surfaces

Plasma Surface Modification of 3Y-TZP at Low and Atmospheric Pressures with Different Treatment Times

Effects of different plasma treatments on bonding properties of zirconia

A low power 50 Hz argon plasma for surface modification of polytetrafluoroethylene

Effect of Non‐Thermal Sulfur Hexafluoride Cold Plasma Modification on Surface Properties of Polyoxymethylene

Study on Hydrophilicity of Polymer Surfaces Improved by Plasma Treatment

Interfacial performance and impact resistance of argon plasma treated UHMWPE/STF inter-ply hybrid composites

Time-related surface modification of denture base acrylic resin treated by atmospheric pressure cold plasma.

Treatment of PDMS surfaces using pulsed DBD plasmas: comparing the use of different gases and its influence on adhesion

Effects of argon plasma treatment on carbon fiber surface characteric and its reinforcing polyimide composites interfacial properties at room and elevated temperatures

Low-temperature plasma modification of polyvinylidene fluoride (PVDF) membrane by graft of styrene in gas

Mesoporous Silica Thin Films Prepared by Argon Plasma Treatment of Sol–gel-Derived Precursor