Abstract:The information of water amount in soil is essential in many fields (e.g. agriculture, forestry, hydrology). Methods to determine water content (WC) can be classified as direct and indirect. Direct methods are connected with the destruction of a sample, are time-consuming and impractical for the measurements in the crop fields. Indirect methods ensure non-destructive and in situ measurements and depend on monitoring a dielectric soil property which is a function of WC. The soil dielectric permittivity is one of the used properties which may be determined by time domain reflectometry (TDR) or frequency domain reflectometry (FDR) techniques. TDR probes are expensive and can be easily damaged at multiple insertions to soil. The open-ended (OE) probes, well-known for their application in the measurements of the complex dielectric permittivity of materials in broadband frequency range, are more resistant to mechanical damage but they are characterized by low penetration depth of electromagnetic waves. Therefore, there is a need to develop sensors able to measure bigger volumes and at the same time sufficiently durable for multiple insertions in soil. &#160;&#160;&#160;&#160;The objective of this work was to test the performance of an open-ended dielectric probe with an antenna (OE-A) in the frequency range 1 MHz &#8211; 6 GHz for two mineral soils using vector network analyzer (VNA) one port (reflective) measurements. Firstly, numerical simulations of the probe using Ansys HFSS software were performed. Secondly, the probe calibration was done on the reference materials (air, distilled water and ethanol). Thirdly, the soils measurements were done to check the possibility to determine soil moisture. &#160;&#160;The obtained results show that the tested probe can be applied for fast moisture measurement with minimal soil disturbance. The real part of dielectric permittivity (&#949;&#8217;) obtained for the tested soils was connected with their moisture and the relation between &#949;&#8217; and volumetric water content was determined. Additionally, the effect of the sample volume was considered and the relation between the high-frequency limit and diameter of the sample was determined. &#160;&#160;&#160;&#160;Acknowledgement:This research was supported by the National Centre for Research and Development (BIOSTRATEG/343547/8/NCBR/2017).

A New Probe for the Investigation of Soil Corrosivity

THE CORROSION MONITORING USING RESISTANCE-PROBE METHOD IN THE CEMENT MOTAR AND COMPARING WITH ELECTROCHEMISTRY-PROBE METHOD

An Easy-to-assemble Probe for in Situ Corrosion Testing of Archaeological Metal

STUDY ON SOIL CORROSION OF CARBON STEEL BY ELECTROCHEMICAL IMPEDANCE SPECTROSCOPY(EIS)

A Method to Measure the Soil Corrosive Rate of Pipe Material

A New Corrosion Sensor To Determine The Start And Development Of Embedded Rebar Corrosion Process At Coastal Concrete

A Newly Designed Tdr Probe for Soils with High Electrical Conductivities

Performance study of novel metal corrosion probes based on the adjust method of series and parallel connections

EMI Instrumented Conical Corrosion Measuring Probe for Pipeline Corrosion Monitoring: Experiments with FEM Validation

ENVIRONMENTAL FACTORS CONTROLLING EARLY CORROSION PERFORMANCE OF CARBON STEEL UNDER LIQUID LAYER CONTAINING SO42

Development and Applications of an In Situ Probe for Multi-Element High-Resolution Measurement at Soil/Sediment-Water Interface and Rice Rhizosphere

A modified dielectric probe for increased measurement volume of soil water content

Numerical Simulation of a Magnetic Corrosion Detector for Corrosion Detection of Steel Rebar in Concrete

Measurements and Analyses of the Corrosive Rates of X52 Pipeline Material in Soil

Development of an electrochemistry-based corrosion sensor to monitor corrosion of boiler tubes, pipes, and painted structures

Investigation on the initial atmospheric corrosion of mild steel in a simulated environment of industrial coastland by thin electrical resistance and electrochemical sensors

Detection of Ionic Contaminants in Unsaturated Soils Using Time Domain Reflectometry Penetrometer

Integrated Study of Geotechnical and Geophysical Methods to Assess the Soil Corrosion Potential for Construction Site

A novel methodology for monitoring low-temperature corrosion caused by hygroscopic salts using linear polarization resistance

INVESTIGATIONS OF CORROSION SENSITIVITY IN TYPICAL SOIL ENVIRONMENTS OF SHAN- JING GAS PIPELINE

A New Method for Corrosion Current Measurement: the Dual-Electrochemical Cell (DEC)