Abstract:Corrosion pits on pipelines lead to the formation of small holes, which cause further pipeline damage and even catastrophic consequences. Since many pipelines are located underground, the detection of corrosion pits on pipelines in real time is still an engineering challenge. In this paper, an experimental feasibility study on pipeline corrosion pit detection using the time reversal technique with a piezoceramic transducer as a time reversal mirror was investigated. A specimen of steel pipeline section was fabricated with an artificially drilled hole, which was to mimic a corrosion pit. By gradually increasing the depth of the hole, the evolution of the corrosion pit on the pipeline was simulated and studied. Two piezoceramic transducers were employed to generate a stress wave to propagate along the pipeline and to detect the propagated stress wave. With both the properties of sensing and actuating functions, a piezoceramic transducer was used as a time reversal mirror, which first detected the propagated stress wave signal and then sent 'back' the time-reversed signal as a propagating stress wave. With the inherent auto-focusing property of the time reversal technique, the detected time-reversed stress wave had a distinct focused peak. A corrosion pit on a pipeline, as a structural defect, reduces the energy of the focused signal received by the piezoceramic sensor and the attenuation ratio of the focused signal depends strongly on the degree of corrosion depth. Experimental results show that the amplitudes of the focused signal peak decrease with the increase of corrosion pit depth and we can use the peak amplitude of the focused signal to determine the state of pipeline corrosion. The time reversal based method proposed in this paper shows the potential to quantitatively monitor the damage degree of corrosion pits on pipelines in real time.

EMI Instrumented Conical Corrosion Measuring Probe for Pipeline Corrosion Monitoring: Experiments with FEM Validation

Experimental and Numerical Analysis of the Impact of Corrosion on Pipeline Failure Pressure

Cloud-based pipe corrosion monitoring using electromechanical impedance instrumented piezoelectric ring sensor

Performance study of novel metal corrosion probes based on the adjust method of series and parallel connections

Modeling and experimental validation of a quantitative bar-type corrosion measuring probe using piezoelectric stack and electromechanical impedance technique

Self-sensing Joints for In-Situ Structural Health Monitoring of Composite Pipes: A Piezoresistive Behavior-Based Method

Study on the effect of corrosion defects on VIV behavior of marine pipe using a new defective pipe element

Study on pipeline corrosion monitoring based on piezoelectric active time reversal method

Piezoelectric Active Sensing-Based Pipeline Corrosion Monitoring Using Singular Spectrum Analysis

Pipeline leak detection and corrosion monitoring based on a novel FBG pipe-fixture sensor

Loosening Monitoring of a Threaded Pipe Connection Using the Electro-Mechanical Impedance Technique-Experimental and Numerical Studies

THE CORROSION MONITORING USING RESISTANCE-PROBE METHOD IN THE CEMENT MOTAR AND COMPARING WITH ELECTROCHEMISTRY-PROBE METHOD

A Novel Pipeline Corrosion Monitoring Method Based on Piezoelectric Active Sensing and CNN

Integrity Assessment of the Pipelines Containing an Isolated Corrosion Pit

Pipeline Elbow Corrosion Simulation for Strain Monitoring with Fiber Bragg Gratings

An experimental feasibility study of pipeline corrosion pit detection using a piezoceramic time reversal mirror

Assessment by finite element modelling of the mechano-electrochemical interaction at corrosion defect on elbows of oil/gas pipelines

A three-dimensional electrode array probe designed for visualising complex and dynamically changing internal pipeline corrosion

A New Corrosion Sensor To Determine The Start And Development Of Embedded Rebar Corrosion Process At Coastal Concrete

Investigation by numerical modeling of the mechano-electrochemical interaction of circumferentially aligned corrosion defects on pipelines

Development of a finite element model for simulation and prediction of mechanoelectrochemical effect of pipeline corrosion