Abstract:PHPs (pulsating heat pipes) are widely used as an efficient heat transfer element in equipment thermal management and waste heat recovery due to their flexibility. The purpose of this study was to design a heat transfer device that utilizes an asymmetric pulsating heat pipe structure by adjusting the lengths of selected pipes within the entire circulation pipeline. In the experiment, a constant temperature water bath was used as the heat source, with heat dissipated in the condensing section via natural convection. An infrared thermal imager was used to record the temperature of the condensing section, and the local wall temperature distribution was measured in different channels of the condensing section. Based on an in-depth analysis of the wavelet frequency, the following research conclusions are drawn: Firstly, as the heat source temperature increases, the start-up time of the pulsating heat pipe is shortened, the operating state changes from start–stop–start to stable and continuous oscillation, and the oscillation mode changes from high amplitude and low frequency to low amplitude and high frequency. These changes are especially pronounced when the heat source temperature is 80 °C, which is when the thermal resistance reaches its lowest value of 0.0074 K/W, and the equivalent thermal conductivity reaches its highest value of 666.29 W/(m·K). Secondly, the flow and oscillation of the working fluid can be effectively promoted by appropriately shortening the length of the condensing section of the pulsating heat pipes or the heat transfer distance between the evaporation and condensing sections. Third, under a low-temperature heat source, the oscillation frequency of each channel of a pulsating heat pipe is found to be low based on wavelet analysis. However, as the heat source temperature increases, the energy content of the temperature signal of the working fluid in each channel changes from a low- to a high-frequency value, gradually converging to the same characteristic frequency. At this point, the working fluid in the pipes no longer flows randomly in multiple directions but rather in a single direction. Finally, we determined that the maximum oscillation frequency of working fluid in a PHP is around 0.7 HZ when using the water bath heating method.

Application of Semiconductor Peltier Characters for Mechanical Pumped Heat Pipe Temperature Control

Experimental Investigation on the Temperature Distribution Characteristics of the Evaporation Section in a Pulsating Heat Pipe

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Experimental investigation on a pulsating heat pipe with low number of turns at liquid hydrogen temperature range

Numerical Study of the Thermal Performance of a Hydrogen Pulsating Heat Pipe

Analysis on Heat Resistance of the Micro Heat Pipe with Arteries

Experimental investigation on the thermal performance of a novel loop heat pipe (LHP) with micro-channel structure

Experimental study of mechanical-capillary driven phase-change loop for heat dissipation of electronic devices and batteries

Experimental investigation on a flat loop heat pipe coupled with thermoelectric cooler

Application Research of Phase Change Material Heat Removal Technology for Compact High Efficiency Diode Pumped Laser

Experimental and simulation study on flow heat transfer characteristics of flat pulsating heat pipe with wide and narrow interphase channels

Evaluation of the Heat Transfer Performance of a Device Utilizing an Asymmetric Pulsating Heat Pipe Structure Based on Global and Local Analysis

Experimental Study on Heat Transfer Performance Using a Hybrid Cooling Method Combined of a Flat-Plate Heat Pipe and Spray Cooling

Thermal management strategy for electronic chips based on combination of a flat-plate heat pipe and spray cooling

Development of hybrid loop heat pipe using pump assistance for cooling application on high heat flux device

Experimental study on a rectangular evaporator loop heat pipe with a phase-change material heat sink

Investigation of a Gas-Pump-Driven Loop Heat Pipe

Design of a Novel Turbine-Pump-driven Loop Heat Pipe and Its Thermodynamic Analysis

Experimental investigation on passive cooling, thermal storage and thermoelectric harvest with heat pipe-assisted PCM-embedded metal foam

Experimental Study of Thermal Performance of Pulsating-Heat-Pipe Heat Exchanger with Asymmetric Structure at Different Filling Rates

Numerical Study on the Cooling Method of Phase Change Heat Exchange Unit with Layered Porous Media