Abstract:Structure and morphology development during the isothermal crystallization and subsequent melting of syndiotactic polypropylene (sPP) was studied with differential scanning calorimetry (I)SQ, time-resolved simultaneous small-angle X-ray scattering (SAXS), and wide-angle X-ray diffraction (WAXD) methods with synchrotron radiation. The morphology of sPP isothermally crystallized at 100 degreesC for 3 h was also characterized with transmission electron microscopy (TEM). Time- and temperature-dependent parameters such as the long period (L), crystal lamellar thickness (l(c)), amorphous layer thickness (l(a)), scattering invariant (Q), crystallinity (X-c), lateral crystal sizes (L-200 and L-010), and unit cell dimensions (a and b) were extracted from the SAXS and WAXD data. Results indicate that the decreases in L and lo with time are probably due to the formation of thinner crystal lamellae, and the decreases in a and b are due to crystal perfection. The changes in the morphological parameters (Q, X-c, L, and l(c)) during subsequent melting exhibited a two-stage process that was consistent with the multiple melting peaks observed in DSC. The two high-temperature peaks can be attributed to the melting of primary lamellae (at lower temperatures) and recrystallized lamellae (at higher temperatures), An additional minor peak, located at the lowest temperature, was also visible and was related to the melting of thin and defective secondary lamellae. TEM results are consistent with the SAXS data, which supports the assignment of the larger value (l(1)) from the correlation function analysis as l(c). WAXD showed that the thermal expansion was greater along the b axis than the a axis during melting. (C) 2001 John Wiley & Sons, Inc.*.

Influence of Syndiotacticity and Annealing Temperature on the Double Melting Peak Behaviour of Syndiotactic Polypropylene

Nonisothermal Crystallization of S-Pp Fractions

Temperature Rising Elution Fractionation of Syndiotactic Polypropylene Prepared by Homogeneous and Supported Metallocene Catalysts

Structure and morphology development in syndiotactic polypropylene during isothermal crystallization and subsequent melting

Polymorphic Behavior of Syndiotactic Polypropylene Induced by Heat Treatment

Single-molecule Study on the Force-Induced Melting in Syndiotactic Polypropylene Single Crystals

Thermorheological Evidence And Structure Of Heterogeneity In Syndiotactic Polypropylene Melts With Strong Memory Effects

Mechanical and thermal induced chain conformational transformations in syndiotactic polypropylene (sPP)

Partial Melting and Recrystallization of Isotactic Polypropylene

Melting Behavior of Polypropylene After Stepwise Isothermal Crystallization and Factors Affecting the Behavior

Supercritical Carbon Dioxide‐induced Melting Temperature Depression and Crystallization of Syndiotactic Polypropylene

Effect of isotacticity distribution on the crystallization and melting behavior of polypropylene

Crystallization of Syndiotactic Polypropylene (spp) from Oriented Melts

Variations of regular conformation structures in melt of syndiotactic polypropylene

Morphologies and Mechanical Properties of Syndiotactic Polypropylene (spp)/ Polyethylene (PE) Blends

Influence of molten-state annealing on the phase structure and crystallization behaviour of high impact polypropylene copolymer

Double Melting Phenomena Of Polyphenylene Sulfide And Its Blends

Multiple Melting Behaviour of Annealed Crystalline Polymers

Microstructural Evolution and Its Effect on Mechanical Properties of Isotactic Polypropylene by Shear Plastic Deformation at Elevated Temperatures

Crystal Structure and Morphology of Syndiotactic Polypropylene Single Crystals

Crystalline Structure Changes in Preoriented Metallocene-Based Isotactic Polypropylene Upon Annealing.