Abstract:Optically transparent polyimide (PI) films with good atomic oxygen (AO) resistance have been paid extensive attention as thermal controls, optical substrates for solar cells or other components for low Earth orbit (LEO) space applications. However, for common PI films, it is usually quite difficult to achieve both high optical transparency and AO resistance and maintain the intrinsic thermal stability of the PI films at the same time. In the current work, we aimed to achieve the target by using the copolymerization methodology using the fluorinated dianhydride 9,9-bis(trifluoromethyl)xanthene-2,3,6,7-tetracarboxylic dianhydride (6FCDA), the fluorinated diamine 2,2-bis [4-(4-aminophenoxy)phenyl]hexafluoropropane (BDAF) and the polyhedral oligomeric silsesquioxane (POSS)-containing diamine N-[(heptaisobutyl-POSS)propyl]-3,5-diaminobenzamide (DABA-POSS) as the starting materials. The fluoro-containing monomers were used to endow the PI films with good optical and thermal properties, while the silicon-containing monomer was used to improve the AO resistance of the afforded PI films. Thus, the 6FCDA-based PI copolymers, including 6FCPI-1, 6FCPI-2 and 6FCPI-3, were prepared using a two-step chemical imidization procedure, respectively. For comparison, the analogous PIs, including 6FPI-1, 6FPI-2 and 6FPI-3, were correspondingly developed according to the same procedure except that 6FCDA was replaced by 4,4′-(hexafluoroisopropylidene)diphthalic anhydride (6FDA). Two referenced PI homopolymers were prepared from BDAF and 6FDA (PI-ref1) and 6FCDA (PI-ref2), respectively. The experimental results indicated that a good balance among thermal stability, optical transparency, and AO resistance was achieved by the 6FCDA-PI films. For example, the 6FCDA-PI films exhibited good thermal stability with glass transition temperatures (Tg) up to 297.3 °C, good optical transparency with an optical transmittance at a wavelength of 450 nm (T450) higher than 62% and good AO resistance with the erosion yield (Ey) as low as 1.7 × 10−25 cm3/atom at an AO irradiation fluence of 5.0 × 1020 atoms/cm2. The developed 6FCDA-PI films might find various applications in aerospace as solar sails, thermal control blankets, optical components and other functional materials.

Synthesis and Properties of PI Films From 2,3,3',4'-Oxydiphthalic Anhydride

Synthesis and Characterization of Semi-Alicyclic Transparent Polyimide Films Containing Benzanilide and Fluorene Units with Improved High-Temperature Dimensional Stability and Low-Optical Retardations

Synthesis and Properties of Cost-Effective Light-Color and Highly Transparent Polyimide Films from Fluorine-Containing Tetralin Dianhydride and Aromatic Diamines

Synthesis and Characterization of Thianthrene-Containing Preimidized Soluble Polyimide Resins and the Derived Films with High Refractive Indices and Good Optical Transparency

Synthesis and Characterization of Organo-Soluble Polyimides Based on Polycondensation Chemistry of Fluorene-Containing Dianhydride and Amide-Bridged Diamines with Good Optical Transparency and Glass Transition Temperatures over 400 °C

Preparation and Characterization of Atomic Oxygen-Resistant, Optically Transparent and Dimensionally Stable Copolyimide Films from Fluorinated Monomers and POSS-Substituted Diamine

Synthesis and Characterization of Polyimide from Hydrogenated Pyromellitic Anhydride

Synthesis and Properties of Optically Transparent Fluoro-Containing Polyimide Films with Reduced Linear Coefficients of Thermal Expansion from Organo-Soluble Resins Derived from Aromatic Diamine with Benzanilide Units

Organosoluble semi-alicyclic polyimides derived from 3,4-dicarboxy-1,2,3,4- tetrahydro-6-tert-butyl-1-naphthalene succinic dianhydride and aromatic diamines: Synthesis, characterization and thermal degradation investigation

Atomic Oxygen-Resistant and Transparent Polyimide Coatings from [3,5-Bis(3-aminophenoxy)phenyl]diphenylphosphine Oxide and Aromatic Dianhydrides: Preparation and Characterization

Preparation and properties of light-colored and transparent semi-alicyclic polyimide films with enhanced flame retardancy from alicyclic dianhydrides and aromatic diamine containing phenolphthalein unit

Preparation and properties of semi-alicyclic thermoplastic polyimide sheets from stereoisomeric hydrogenated pyromellitic dianhydrides and fluorinated diamine

Synthesis and properties of fluorinated polyimides from 1,1-bis(4-amino-3,5-dimethylphenyl)-1-(3,4,5-trifluorophenyl)-2,2,2-trifluoroethane and various aromatic dianhydrides

Molecular Design, Synthesis and Characterization of Intrinsically Black Polyimide Films with High Thermal Stability and Good Electrical Properties

Based on Rigid Xanthone Group and Hydrogen Bonding to Construct Polyimide Films with Low Coefficient of Thermal Expansion, High Temperature Resistance, and Fluorescent Property

Colorless and transparent semi‐alicyclic polyimide films with intrinsic flame retardancy based on alicyclic dianhydrides and aromatic phosphorous‐containing diamine: Preparation and properties

Synthesis of Highly Transparent and Thermally Stable Copolyimide with Fluorine‐containing Dianhydride and Alicyclic Dianhydride

Microwave-assisted Synthesis of High Thermal Stability and Colourless Polyimides Containing Pyridine

Synthesis and characterization of highly refractive polyimides from 4,4′-thiobis[(p-phenylenesulfanyl)aniline] and various aromatic tetracarboxylic dianhydrides

Synthesis of Novel Biphenyl‐fused Alicyclic Tetracarboxylic Dianhydride and Its Performance in Thermostable and Transparent Colorless Polyimides

Preparation and Characterization of Semi-Alicyclic Polyimides Containing Trifluoromethyl Groups for Optoelectronic Application