Abstract:Two semi-alicyclic thermoplastic polyimides (PI) have been prepared from stereoisomeric hydrogenated pyromellitic dianhydrides, including 1S,2R,4S,5R-hydrogenated pyromellitic dianhydride (ccHPMDA or H-PMDA) and 1R,2S,4S,5R-hydrogenated pyromellitic dianhydride (ctHPMDA or Hʹʹ-PMDA) and a fluorine-containing diamine, 2,2-bis[4-(4-aminophenoxy)phenyl]hexafluoropropane (BDAF), respectively. The derived PI-1 (ccHPMDA-BDAF) and PI-2 (ctHPMDA-BDAF) resins were easily soluble in polar aprotic solvents, such as N -methyl-2-pyrrolidinone (NMP) and N,N -dimethylacetamide (DMAc) and meanwhile they also exhibited good thermoplasticities. Thus, the PI films (thickness: ~25 μm) and sheets (thickness: ~3 mm) were separately prepared from the PI solutions in DMAc and the PI powders, respectively. The stereoisomeric effects in the ccHPMDA-derived PI-1 and the ctHPMDA-derived PI-2 apparently affected the melt-flowability of the polymers. PI-2 exhibited lower melting viscosities than that of the PI-1 counterpart. The PI sheets exhibited obviously reduced optical transparency compared with those of the PI films; however better optical transparency than those of the common thermoplastic PI sheets. For example, PI-2 sheet showed the optical transmittance value at the wavelength of 760 nm (T 760 ) of 69.6%, which was 19.5% lower than that of the analogous PI-2 film (T 760 = 89.1%), however 50.3% and 65.7% higher than those of the commercially available PI-ref1 sheet (T 760 = 19.3%) derived from 3,3ʹ,4,4ʹ-oxydiphthalic dianhydride (ODPA) and 4,4ʹ-oxydianiline (ODA) and the PI-ref2 sheet (T 760 = 3.9%, Aurum ® PL450C, Mitsui Chem. Co, Ltd., Japan), respectively. Meanwhile, the PI-1 and PI-2 sheets showed the heat deflection temperatures (HDT) of 261.0 °C and 265.0 °C, respectively, which were obviously higher than those of the referenced PIs. At last, the PI sheets exhibited good mechanical properties, including high flexural strength (130.0 ~ 132.0 MPa), flexural modulus (2.87 ~ 2.96 GPa), compression strength (124.4 ~ 149.3 MPa), compression modulus (1.49 ~ 1.59 GPa), and impact strength (129.0 ~ 139.6 KJ/m 2 ).

Synthesis and Characterization of Polyimide from Hydrogenated Pyromellitic Anhydride

Structure and Properties of Thermoplastic Polyimide Based on 4', 4'-(Oxybis (methylene)) Bis ([1.1'- Bipheny]3-Amine) Diamine

Synthesis and characterization of highly refractive polyimides from 4,4′-thiobis[(p-phenylenesulfanyl)aniline] and various aromatic tetracarboxylic dianhydrides

Synthesis and Characterization of Pyridine-Bridged Fluorinated Polyimides

Preparation and properties of semi-alicyclic thermoplastic polyimide sheets from stereoisomeric hydrogenated pyromellitic dianhydrides and fluorinated diamine

Synthesis and properties of polyimides from a diamine containing side diphenylphosphine oxide and trifluoromethyl groups

Study on Syntheses and Properties of Some Novel Polyimides Containing Bisthiazole Rings

Molecular Design, Synthesis and Characterization of Intrinsically Black Polyimide Films with High Thermal Stability and Good Electrical Properties

Microwave-assisted Synthesis of High Thermal Stability and Colourless Polyimides Containing Pyridine

Synthesis and Characterization of Polyimides Derived from 5-Amino-2(p-aminophenyl) Benzoxazole Monomer

Synthesis and Characterization of Asymmetric Polyimides with High Transparency

Synthesis and Characterization of Semi-Alicyclic Transparent Polyimide Films Containing Benzanilide and Fluorene Units with Improved High-Temperature Dimensional Stability and Low-Optical Retardations

Synthesis and Properties of PI Films From 2,3,3',4'-Oxydiphthalic Anhydride

Soluble Polyimides Derived from a Novel Aromatic Diamine Containing an Imidazole Unit and Trifluoromethyl Groups

Synthesis and Characterization of Polyimides from 4,4′-(3-(tert-butyl)-4-aminophenoxy)diphenyl Ether

Synthesis and properties of fluorinated polyimides from 1,1-bis(4-amino-3,5-dimethylphenyl)-1-(3,4,5-trifluorophenyl)-2,2,2-trifluoroethane and various aromatic dianhydrides

Modification of Polyimide Films by Copolymerization and Blending

Synthesis and Properties of a High‐molecular‐weight Poly(amic Acid) and Polyimide Based on 2,2‐Bis(3‐amino‐4‐hydroxyphenyl)hexafluoropropane

Characterization and Thermal Degradation of Polyimide Derived from 5-Amino-2(p-aminophenyl) Benzoxazole Monomer with Pyromellitic Dianhydride

Synthesis and Characterization of High Refractive Index Polyimides Derived from 4,4′-( p -Phenylenedisulfanyl)dianiline and Various Aromatic Tetracarboxylic Dianhydrides

Synthesis and Characterization of Thioether and Pyridine-Bridged Aromatic Polyimides with High Refractive Indices and High Glass Transition Temperatures