Abstract:The liquid-phase method of synthesis of lithium iron(II) phosphate (LiFePO4) in the medium of choline chloride and diethylene glycol under the action of microwave heating is proposed. With a power of microwave radiation of 920 and 1150 W, a nanocrystalline LiFePO4 without impurities was obtained. Obtained samples of microwave processes contain amorphous phase and require long annealing resulting in nanocrystalline LiFePO4/C composites with small impurities Li3PO4, Li3Fe2(PO4)3, Fe2O3. For samples obtained in the choline chloride with diethylene glycol microwave heating characteristic is lamellar morphology – the same as for LiFePO4 obtained by thermal heating, but in the case of using microwave irradiation plates are smaller. This indicates that the reaction mechanism of LiFePO4 synthesis does not change in the microwave synthesis, but the reaction rate is significantly increased (up to 6 times faster than thermal synthesis). Using the Raman spectroscopy, the nature of the carbon coating on the crystal of LiFePO4 was studied. The Raman spectra of the LiFePO4/C composites obtained from an annealed powder with glucose and malic acid have pronounced D (~ 1340 cm-1) and G (~ 1600 cm-1) peaks, as well as two additional bands at ~ 1200 and ~ 1520 cm-1 obtained after the expansion of main peaks. The ratio of peak intensities of lines D and G (ID/IG) has a value of 1.06 for the material obtained after glucose carbonation and 1.01 for LiFePO4/C composites annealed with malic acid, which correlates with the results of other investigations of the carbon coating LiFePO4 (ID/IG ~ 1-3) That means the choice of an organic precursor does not affect the nature of the carbon coating (ID/IG ~ 1). Capacity of cathode material based on LiFePO4/C composites is ~ 130 mAh/g for a current of 0.1C.

Characteristics of LiFePO4 synthesized from NH4FePO4-H2O via microwave processing

Preparation and characterization of LiFePO 4 from NH 4 FePO 4 ·H 2 O under different microwave heating conditions

Preparation and Characterization of LiFePO4 Made from NH4FePO4·H2O

Preparation and characterization of LiFePO4 made from NH4FePO4 center dot H2O

SYNTHESIS OF LiFePO4 NANOCRYSTALS IN THE ION-LIQUID MEDIUM USING MICROWAVE HEATING

Synthesis Of Cathode Material "Carbon-Included" Lifepo4 By Microwave Heating

LiFePO4/C Cathode Materials Synthesized by Co-Precipitation and Microwave Heating

Preparation and Characterization of Nano-Sized LiFePO4 by Low Heating Solid-State Coordination Method and Microwave Heating

Microwave synthesis of molybdenum doped LiFePO4/C and its electrochemical studies

Nano-LiFePO[sub 4]∕MWCNT Cathode Materials Prepared by Room-Temperature Solid-State Reaction and Microwave Heating

High Density LiFePO4/C Synthesized by Controlled Crystallization and Microwave Carbon Thermal Reduction

Synthesis of Nano-Sized FePO4 Cathode Material via a Microemulsion Technique

Electrochemical Performances of Nonstoichiometric Li1+xFePO4 Microspheres by Microwave-Assisted Hydrothermal Synthesis

Synthesis of nano FePO 4 and electrochemical characterization of composite cathode material LiFePO 4/C

Preparation and characterization of nanoscale LiFePO 4 cathode materials by a two-step solid-state reaction method

Synthesis of Nano-Sized FePO<sub>4</sub> Cathode Material Via a Microemulsion Technique

Synthesis of Nano-Sized FePO<sub>4</sub> Cathode Material via a Microemulsion Technique

Controllable Synthesis and Morphology Evolution of Hierarchical LiFePO4 Cathode Materials for Li-ion Batteries

Preparation and Characterization of LiFePO[sub 4] from a Novel Precursor of NH[sub 4]fepo[sub 4]⋅h[sub 2]O

Synthesis and Characterization of LiFePO4 Nanoparticle/Mesoporous Carbon Composites As High-Power Cathode Materials for Lithium-Ion Batteries

Characterization of LiFePO<sub>4</sub> Synthesized by Sol-Gel Processing