Abstract:As a newly emerged active flow control technique, micro blowing/suction has shown a great potential in reducing the skin friction of turbulent flows. Throughout comprehensive analyses of active flow control of micro blowing/suction devices for a NACA0015 airfoil by means of CFD technique, the effects on various characteristics such as lift and drag coefficients and separation areas are investigated in this study. The control devices were placed at 12%c, 30%c and 70%c from the leading edge (c is the chord length of the airfoil), respectively. The corresponding trends of flow separation control at these locations were analyzed with a varied range of angle of attacks (AOA). The two- and three-dimensional incompressible unsteady detached-eddy simulation (DES) was used, along with the k-e turbulence model, in solving the flow problem. The numerical computational results have demonstrated that: (1) Installing micro blowing/suction devices near the separation point is more efficient, as blowing can mix the jet flow and the incoming flow to energize the turbulent kinetic energy and suction can mitigate the flow of low turbulent kinetic energy, which leads to a result of reducing the separation. (2) Suction sometime has more effective influence than blowing, when the flow control devices are placed at 12%c and 30%c. When the control device is placed at 70%c, the effects of lift enhancement and drag reduction are almost the same regardless of blowing and/or suction method. When the AOA is less than 18°, both methods can achieve the goal of lift enhancement and drag reduction. When the AOA is larger than 18°, neither blowing nor suction is efficient. (3) The 3-D numerical simulation shows that the vortex structure evolves from a 2-D pattern near the separation point to a 3-D pattern in the downstream. However the characteristics of flow separation control over a 3-D airfoil simulation agrees well with 2-D numerical results. (4) Blowing at 30%c can move the separation point downstream from 70%c to 80%c at AOA=11°.

ADVANCES OF ACTIVE FLOW CONTROL BASED ON MEMS TECHNOLOGY

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

ACTIVE FLOW CONTROL APPLICATIONS WITH ZERO NET MASS FLUX ACTUATOR IN FLOW FIELD OF SUPERSONIC INLET

MICRO-ELECTRO-MECHANICAL-SYSTEMS (MEMS) AND FLUID FLOWS

Coupled dynamics of steady jet flow control for flexible membrane wings

A Review of Flow Control Strategies for Supersonic/Hypersonic Fluid Dynamics

PROGRESSES ON MICROMACHINED FLOW SENSORS BASED ON MEMS TECHNOLOGIES

Opportunities and challenges of MEMS technology in the environment of intelligent aero-engines

Numerical Analysis Of Active Flow Control Around Airfoil By Synthetic Jet Technology In Low Reynolds Number

Enhancing Stability and Performance of Flexible Membrane Structures in Wake Flows Through Jet Flow Control

Numerical Study and Flight Control of Active Flow Control Based on Plasma Synthetic Jet

Applications and developments of aeroelasticity of flexible structure in flow controls

Liquid Dynamic Mass Flow Controller

Review: MEMS sensors for flow separation detection

Rarefied Couette Flows Performance in Micro Fluid Machinery Based on Improved DSMC Method

Coupled Analysis on the Micro-Airflow and Its Actuator for Mems Fluidic Devices

Research on Development and Application of the Coflow Jet Technology

Investigation of Practical Flow Control Methodologies with RANS/LES Hybrid Methods

Design and development of MEMS based beam-membrane structure flow sensor

Learning Active Flow Control Strategies of a Swept Wing by Intelligent Wind Tunnel