Hybrid Non-Uniform- Q Lossy Filters with Substrate Integrated Waveguide and Microstrip Resonators
Liang-Feng Qiu,Lin-Sheng Wu,Wen-Yan Yin,Jun-Fa Mao
DOI: https://doi.org/10.1049/iet-map.2017.0060
2017-01-01
Abstract:Three lossy filters with flat passband are proposed with substrate integrated waveguide (SIW) and microstrip resonators, designed with the non-uniform-Q method. By properly selecting the lower-Q-to-higher-Q ratio, the 0.2dB bandwidth of the first filter is obtained to be 215MHz (17% improvement), which is equivalent to a uniform unloaded Q-factor of 820 at the cost of additional in-band insertion loss (IL) of 0.5dB, when compared with the full-SIW filters. Further, two techniques are utilised to adjust the Q-factor ratio. One method is implemented by mounting a resistor on each microstrip resonator to reduce its unloaded Q-factor. Then, the 0.2dB passband of 243MHz is achieved for the second filter, equivalent to a uniform unloaded Q-factor of 1420. The other method is realised by adjusting the Q-factor due to radiation loss of microstrip resonators. By changing the input/output feeding structures, the 0.2dB bandwidth of the third filter is enhanced by 32%, at the cost of minimum IL increased by 0.9dB. The occupied area of the proposed planar hybrid filters is reduced by 15-21% and the passband flatness is much better than that of the uniform-Q filter counterparts, as demonstrated by the simulated and measured results