Abstract:It is of great significance for structural design and engineering evaluation to obtain the elastic–plastic parameters of materials. The inverse estimation of elastic–plastic parameters of materials based on nanoindentation technology has been applied in many pieces of research, but it has proved to be difficult to determine the elastic–plastic properties of materials by only using a single indentation curve. A new optimal inversion strategy based on a spherical indentation curve was proposed to obtain the elastoplastic parameters (the Young's modulus E, yield strength σy, and hardening exponent n) of materials in this study. A high-precision finite element model of indentation with a spherical indenter (radius R = 20 μm) was established, and the relationship between the three parameters and indentation response was analyzed using the design of experiment (DOE) method. The well-posed problem of inverse estimation under different maximum indentation depths (hmax1 = 0.06 R, hmax2 = 0.1 R, hmax3 = 0.2 R, hmax4 = 0.3 R) was explored based on numerical simulations. The results show that the unique solution with high accuracy can be obtained under different maximum press-in depths (the minimum error was within 0.2% and the maximum error was up to 1.5%). Next, the load-depth curves of Q355 were obtained by a cyclic loading nanoindentation experiment, and the elastic–plastic parameters of Q355 were determined by the proposed inverse-estimation strategy based on the average indentation load-depth curve. The results showed that the optimized load-depth curve was in good agreement with the experimental curve, and the optimized stress–strain curve was slightly different from the tensile test, and the obtained parameters were basically consistent with the existing research.

Influence of hardening behaviour of elastoplastic materials on the determination of elastic modulus using indentation tests

DETERMINING THE ELASTIC MODULUS OF LINEARLY HARDENING ELASTOPLASTIC MATERIALS USING INDENTATION TESTS

An Inverse Approach to Determine the Mechanical Properties of Elastoplastic Materials Using Indentation Tests

A further study on representative models for calculating the residual stress based on the instrumented indentation technique

Data-driven estimation of plastic properties in work-hardening model combining power-law and linear hardening using instrumented indentation test

Determination of mechanical properties from sharp dynamic indentation

Research on Determining Elastic–Plastic Constitutive Parameters of Materials from Load Depth Curves Based on Nanoindentation Technology

Identification of plastic properties through spherical indentation

Influence of the Mechanical Properties of Elastoplastic Materials on the Nanoindentation Loading Response

Determining plastic properties of a material with residual stress by using conical indentation

An elastic-plastic indentation model for different geometric indenters and its applications

Determine the unique constitutive properties of elastoplastic materials from their plastic zone evolution under nanoindentation

On the Determination of Reduced Young's Modulus and Hardness of Elastoplastic Materials Using a Single Sharp Indenter

Spherical Indentation Method for Determining the Constitutive Parameters of Hyperelastic Soft Materials

Spherical Indentation into Elastoplastic Materials: Indentation-response Based Definitions of the Representative Strain

Measuring elastic parameters of transversely isotropic materials by cylindrical indentation

Determination of elastoplastic properties in anisotropic materials with cubic symmetry by instrumented indentation

Measuring elastoplastic properties of thin films on an elastic substrate using sharp indentation

Study Of Flexural Response In Strain Hardening Cementitious Composites Based On Proposed Parametric Model

A study of the elastic moduli of corrosion products using nano-indentation techniques

An Energy-Based Method to Extract Plastic Properties of Metal Materials from Conical Indentation Tests