Abstract:Fillet welds by intermittent welding are widely used in the welding of centrifugal fans, such as attaching a fan blade to the rear plate. The intermittent welding method transforms the full-length continuous weld into multiple short welds to minimize distortion by reducing the total heat input for a welded joint to control welding distortion. An infinite number of short welds are created during this process. However, depending on the complexity of the model, the computational cost of predicting welding distortion based on full-scale modeling is considerable. These numerous short welds undoubtedly complicate modeling and computations, limiting rapid distortion prediction for large and complex structures. This study develops an equivalent deformation calculation approach based on a local-to-global technique and applies it to predict distortion of a fillet joint welded specimen. The approach consists of two steps. First, the welding-induced structural deformation is calculated for a two-dimensional (2D) weld and a 2D heat-affected zone (local calculation). Second, the 2D structural deformation is applied to the full-scale welded structure using a nearest-point spatial interpolation algorithm to acquire the three-dimensional (3D) equivalent deformation (global calculation). Note that the weld shape was considered in both local and global calculations. In addition, welding tests were performed, and the coordinates of the key points were measured. The geometric parameters of the welds used in the numerical simulations were obtained from experimental observations. Finally, the key point coordinates obtained by the proposed approach were compared with experimental measurements. Furthermore, the distribution of out-of-plane distortion caused by the new approach was compared with the simulation results of the thermo-elastic-plastic method performed on a full-scale welded structure. The proposed approach can be verified by both comparisons.

FEM-based prediction of distribution of flow line within large monolithic forging

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Flow defects of rib-web components in isothermal local-loading forming process

Failure Prediction in Bulk Metal Forming Process

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

A Non-Ideal Geometry Based Prediction Approach of Fitting Performance and Leakage Characteristic of Precision Couplings.

Prediction of forming limit in the hydroforming processes by using FEM and fracture criterion

Prediction of the fatigue curve of high-strength steel resistance spot welding joints by finite element analysis and machine learning

Prediction and Analysis of Breakthrough Extruding Force Based on a Modified FE-model in Large-Scale Extrusion Process

Prediction of forming limit for sheet metals between equi-biaxial tension and uniaxial tension using a new ductile fracture criterion

Prediction of distortion in a thin-plate structure with intermittent fillet joints using a local-to-global approach

Defects analysis of the ultra-thick steel pipes using a mixed explicit–implicit FEM

Predictive modeling of Loading paths for Hydroforming of bi-layered Y-shaped tubes

Shared mechanism between flow drill screw and friction stir welding and its impact on failure prediction of steel-aluminum joints

Numerical prediction of ductile fracture in multi-stage single point incremental forming based on phenomenological modified Mohr–Coulomb

The Line-heating Deformation Prediction Method Based on FEA and ANN

Incremental Formulation for the Prediction of Flow Stress and Microstructural Change in Hot Forming

Simulation of material plastic flow driven by non-uniform friction force during friction stir welding and related defect prediction

Predicting Residual Distortion of Aluminum Alloy Stiffened Sheet after Friction Stir Welding by Numerical Simulation

Mathematical modeling and simulated analysis of metal flow behavior during the FGC of ESP rolling process