Abstract:In this paper, the effect of micro-dimple textures (produced by a laser) on the tribological properties of bearings is investigated. This study offers guidelines to reduce the friction torque of the bearing pair and addresses the problem of difficult start-ups after shutdowns. Micro-pits with different texture diameters and depths were machined on the surface of journal bearings. Then, the impact of several different texture parameters on the tribological performance of the bearing pairs was studied using an orthogonal experimental design. Subsequently, the surface morphology of the bearings before and after the friction and wear test was observed using scanning electron microscopy (SEM) and energy-dispersive spectrometry (EDS). These observations were then used to determine the type/state of friction and wear, which also improves our understanding of how texture affects the service life of bearings. The results indicate that the bearings’ micro-pit surface hardness follows an approximate parabolic spatial distribution that decreases along the micro-pit wall. Furthermore, the laser processing of surface textures was found to cause hardening in certain areas, and the chemical composition of elemental carbon and oxygen at the inner surface of processed bearings increased by 31.1% and 7.9%, respectively. Moreover, abrasive wear was identified as the primary form of wear. The textured surface’s antifriction mechanism primarily functioned to trap particles, which acted as a secondary lubrication source and altered the lubrication states by serving as a medium for supplied lubricants. The results confirm that a suitable selection of texture parameters can not only effectively reduce the friction coefficient without shortening the service life of the bearing pair but also facilitate the smooth start-up of the rotor–bearing system.

Parametric Optimization of Circular Micro-pit Textures in Infinite Contact Area

Effect of Surface Texture Distribution Parameters on Hydrodynamic Lubrication and Numerical Optimization

Numerical Simulation and Experimental Investigation on Tribological Performance of Micro-Dimples Textured Surface under Hydrodynamic Lubrication

Numerical Investigation of the Tribological Performance of Micro-Dimple Textured Surfaces under Hydrodynamic Lubrication

Numerical Optimization of Gourd-Shaped Surface Texture and Experiment of Tribological Performance

Parametric Design of Surface Textures on Journal Bearing

An Analytical And Experimental Parametric Study of Texturing In Slider Bearings Under Hydrodynamic/Mixed Lubrication

Numerical Methods for Improving the Optimization Efficiency of Textured Surfaces

Improvement of Tribological Behaviors by Optimizing Concave Texture Shape Under Reciprocating Sliding Motion

Optimization of Performance Parameters and Mechanism of Bionic Texture on Friction Surface

Research on Internal Flow Field Characteristics of Straight-Groove Texture Using Three-Dimensional Modeling

Surface Tribological Properties Enhancement Using Multivariate Linear Regression Optimization of Surface Micro-Texture

Optimal Analysis of Geometric Parameters of Surface Texture with Surface Tension Considered

Optimization of surface texture distribution on the thrust bearing using the mass-conserving cavitation boundary condition: Theory and experiments

Tribological Performance of Circular-Concave-and-Spherical-Convex Compound Texture under Hydrodynamic Lubrication

A Study on Micro-Pit Texture Parameter Optimization and Its Tribological Properties

Impact Evaluation Approach of a Texture Cross Section Shape on Hydrodynamic Lubrication Performance

Tribology Properties of Textured Surface with Ring-shape Pits

Optimal design of surface texture in meso scale air journal bearing

A Mixed Lubrication Model for Studying Tribological Behaviors of Surface Texturing

Macro-texture in Hydrodynamic Lubrication: Effects of Dimple Parameter, Density and Distribution