Microstructure evolution and fracture behavior of Ti-5Al-3Mo-3V-2Zr-2Cr-1Nb-1Fe alloy during BASCA heat treatments
Huan Wang,Yongqing Zhao,Qinyang Zhao,Shewei Xin,Wei Zhou,Weidong Zeng
DOI: https://doi.org/10.1016/j.matchar.2021.110975
IF: 4.537
2021-04-01
Materials Characterization
Abstract:<p>The microstructure evolution and fracture behavior of Ti-5Al-3Mo-3V-2Zr-2Cr-1Nb-1Fe (Ti-5321) alloy during BASCA (β annealed with subsequent slow cooling & aging) heat treatment were studied. Three different lamellar microstructures, termed as L1, L2 and L3, were obtained by solution treated at 880 °C for 2 h followed by 0.5 °C/min cooling to 800 °C, 750 °C and 710 °C, respectively and aging at 580 °C for 6 h. Microstructural investigation revealed that the three lamellar microstructures were composed of intergranular precipitation (α<sub>GB</sub>, α<sub>WGB</sub>), intragranular α<sub>l</sub> and β<sub>t</sub>. Both of the volume fraction of lamellae α and the size of α colonies increased with the increasing furnace cooling time. Both intergranular and intragranular precipitation in L1, L2 and L3 obeyed the Burgers orientation relationship (OR) with adjacent β grain. However, the texture intensity and variant selection degree of lamellar α increased with cooling process owing to the increased amount of α colonies. In addition, the L1 sample, with 15% α<sub>l</sub>, displayed the lowest fracture toughness value (57.7 MPa·m<sup>1/2</sup>), while the L3 sample with 61% α<sub>l</sub> exhibited the highest (114 MPa·m<sup>1/2</sup>). Although the crack path in all the cases were both translamellar and interlamellar, fracture mode varied from mixed mode (dimples and intergranular cracks) type fracture in L1 to predominantly dimple fracture in L2 and L3. Moreover, the fracture behavior of Ti-5321 alloy was also related to the crystallographic distribution and variation selection of α phase. Crack growth was much easier through continuous α<sub>GB</sub> layer compared to the discontinuous α<sub>GB</sub>, especially for the high angled α<sub>GB</sub>/α<sub>GB</sub> grain boundary. As a consequence, the higher probabilities of misorientation angles of 90° in L1 and L3 could significantly promote crack deflection compared to L2.</p>
materials science, multidisciplinary,metallurgy & metallurgical engineering, characterization & testing