Abstract:The stabilization of isotropic pitch (IP)-derived pitch fibers (PFs) and mesophase pitch (MP)-derived PFsin air was performed at different heating rates and with different final stabilization temperatures. The stabilized fibers (SFs) and carbon fibers (CFs) were characterized by elemental analysis, FT-IR, TG-MS and SEM to investigate the influence of the degree of oxidation of the SFs on the microstructures and mechanical properties of the CFs. Results showed that a slow heating rate during stabilization was beneficial to the oxidative cross-linking of PFs, and the corresponding CFs had a higher carbonization yield and tensile strength at the lower heating rate. When both IPF and MPF were stabilized at 270 oC, the two resulting CFs all reached their optimal performance. In addition, the FTIR peak intensity ratio of the C=O band at about 1700 cm–1 to the C=C band at 1600 cm–1 of the SFs had a good relationship to the carbonization yield and tensile strength of the CFs, and thiscan beusedto optimize the degree of oxidation of the SFs. Moreover, insufficiently stabilized fibers released a great deal of H2 and CH4, causing some porosity in the resulting CFs with a low tensile strength, especially forthe insufficiently stabilized IPCF. While over-stabilized fibers released a large amount of CO and CO2, causing cracked textures in the corresponding CFs, especially inthe over-stabilizedMPCF. Therefore, this research into the stabilization and carbonization behaviors of pitch fibers has great significance for improving the mechanical properties of pitch-based CFs.

Effect of Preoxidation on Microcracks in Graphite Foams

Preparation and Performance of Mesophase Pitch Based Graphite Foam

Effects of Mesophase Pitch Raw Material on the Properties and Crystal Structure of Graphite Foams

Preparation and Performance of Mesophase Pitch Based Carbon Foam

Preparation and Foaming Mechanism of Carbon Foams by Supercritical Foaming Method

Effect of Iron Nitrite on the Preparation of Carbon Foams from Mesophase Pitch

Effects of the degree of oxidation of pitch fibers on their stabilization and carbonization behaviors

Effect of Oxidative Stabilization on the Sintering of Mesocarbon Microbeads and A Study of Their Carbonization

Preparation of carbon foams with supercritical toluene

Influence of Oxygen Uptake on Pitch Carbon Fiber

Effect of pre-oxidation temperature and heating rate on the microstructure of lignin carbon fibers

Effects of Oxygen Content of Pitch Precursors on the Porous Texture and Surface Chemistry of Pitch-Based Activated Carbon Fibers

Improving carbon/carbon composites mechanical and thermal properties by the co‐carbonization of pre‐oxidized carbon fiber and pitch

Effects of Preparation Temperature of Graphite Oxide on the Structure of Graphite and Electrochemical Properties of Graphene-Based Lithium-Ion Batteries

Effect of oxygen-introduced pitch precursor on the properties and structure evolution of isotropic pitch-based fibers during carbonization and graphitization

Preparation and characterization of pitch coke from oxidized polymerized pitch

Influence Of Coal Preoxidation On The Porosity Of The Activated Carbons With Steam Activation

The Effect of Microstructure on Air Oxidation Resistance of Nuclear Graphite

High-temperature oxidation behaviour and influence on the fracture property of compacted graphite iron

A statistical analysis of pores and microcracks in nuclear graphite

Microfluidic Oxidation of Graphite in Two Minutes with Capability of Real‐Time Monitoring