Abstract:The introduction of aliphatic structure by co‐carbonization of coal tar pitch and atmospheric residual provides more methylene bridge bonds and more α‐hydrogens for spinnable pitch, which makes pitch molecular more linear and naphthenic. The α‐hydrogens of aliphatic structure of the CCA‐3 are easily attacked by oxygen, showing a higher oxidative stabilization efficiency. The obtained pitch‐based carbon fiber shows excellent mechanical properties. As a pivotal step in the preparation of carbon fiber, oxidative stabilization not only plays a crucial role in maintaining fibrous morphology but also contributes significantly to enhance mechanical properties of resultant carbon fiber. Due to high activation energy of pitch molecules reaction with oxygen and the sluggish diffusion of oxygen within the fiber, the improvement of oxidative stabilization efficiency faces significant challenges. Atmospheric residual (AR) has a high and easily oxidized aliphatic structure. Spinnable pitch is synthesized by co‐carbonization of coal tar pitch (CTP) and AR at a ratio of 3:1 in this work. Its methylene bridge bond ratio is 4.45% and have an appropriate amount aliphatic structure, which makes pitch molecular more linear and naphthenic. Excessive addition of AR is detrimental to spinning performance. The most optimal oxidative stabilization temperature of as‐spun fiber was 280°C, which is lower than that of fiber produced by CTP alone (300°C), displaying a higher oxidative stabilization efficiency. The obtained pitch‐based carbon fiber shows excellent mechanical properties with tensile strength of 999.0 ± 80.1 MPa and Young's modulus of 57.7 ± 3.5 GPa. The co‐carbonization by two different substances has been applied in manufacturing carbon fiber, providing a facile approach to accelerate the oxidative stabilization of pitch fiber.

Effect of oxygen-introduced pitch precursor on the properties and structure evolution of isotropic pitch-based fibers during carbonization and graphitization

Influence of Oxygen Uptake on Pitch Carbon Fiber

Effects of the degree of oxidation of pitch fibers on their stabilization and carbonization behaviors

Modification of isotropic pitch by tailoring chemical structure and fraction contents for enhancing carbon fiber mechanical properties

Molecular structure effects of mesophase pitch and isotropic pitch on morphology and properties of carbon nanofibers by electrospinning

Investigation on promotion effect of oxidative stabilization for pitch‐based fiber by co‐carbonization of coal tar pitch and atmospheric residual

Enhancing spinnability and properties of carbon fibers through modification of isotropic coal tar pitch precursor

Improving carbon/carbon composites mechanical and thermal properties by the co‐carbonization of pre‐oxidized carbon fiber and pitch

In-Situ Doping B4C Nanoparticles in Mesophase Pitch for Preparing Carbon Fibers with High Thermal Conductivity by Boron Catalytic Graphitization

The effect of the molecular structure of naphthalene-based mesophase pitch on the properties of carbon fibers derived from it

Unveiling the microcrystal structure evolution of carbon fibers induced by thermal soaking of mesophase pitch

Study on structures and properties of isotropic pitches and carbon fibers from co-carbonization of aromatic-rich distillate oil and polyethylene glycol

Evaluating of the oxidative behaviors of isotropic pitch fractions for optimal the mechanical properties of isotropic pitch-based carbon fibers

Controllable Preparation of Spinnable Isotropic Pitches for Carbon Fibers with High Tensile Strength from Low-Cost Ethylene Tar Pitch by a Selective Photobromination–debromination Method

Preparation of pitch precursor with excellent spinnability for general-purpose carbon fibre using coal tar pitch as raw material

Spinnable Mesophase Pitch Prepared via Co-carbonization of Fluid Catalytic Cracking Decant Oil and Synthetic Naphthalene Pitch

Improving the mechanical properties and thermal conductivity of mesophase-pitch-based carbon fibers by controlling the temperature in industrial spinning equipment

Mesoscopic structure and properties of liquid crystalline mesophase pitch and its transformation into carbon fiber

Constructing the Bridge from Isotropic to Anisotropic Pitches for Preparing Pitch-Based Carbon Fibers with Tunable Structures and Properties

Reformation of Naphtha Cracking Bottom Oil for the Preparation of Carbon Fiber Precursor Pitch

A comprehensive study on the effect of carbonization temperature on the physical and chemical properties of carbon fibers