Abstract:To determine all the material constants of a piezoelectric crystal using the IEEE resonance method or ultrasonic method, several samples with specific geometries and orientations are required, and the obtained results may be somewhat self-contradictory. The resonant ultrasound spectroscopy (RUS) can determine full material constants of a single piezoelectric sample by matching the numerically computed eigenfrequencies to the measured resonance spectrum. However, typically the usage of PZT transducers for excitation and reception makes the testing complicated and may add additional mass and damping. In this work, we propose a new method called partial electrode electromechanical impedance spectroscopy (PE-EMIS), which can obtain all the elastic, piezoelectric constants, and related internal frictions of a piezoelectric crystal by just using a single sample without additional transducers. In PE-EMIS, two small PEs are fabricated on one corner of a piezoelectric sample, and the sample's resonance frequencies, along with the internal frictions of the k th eigenmode, can be accurately obtained from the conductance spectrum measured using an impedance analyzer. The PE-EMIS experiment is carried out on a rectangular parallelepiped PZT-4 piezoelectric ceramic, and the extracted material constants are highly repeatable. Three of the extracted elastic constants ( c11E , c33D , and c66E ) are validated by the traditional wave propagation method. Due to its simplicity, convenience, and accuracy, the proposed PE-EMIS is expected to be widely used for characterization of piezoelectric materials in near future.

Measurement of elastic constants of limited-size piezoelectric ceramic sample by ultrasonic method

Mathematical Modelling of One-Dimensional Piezoelectric Transducers Based on Monoclinic Crystals

A New Method for Measuring Elastic Constants of Limited-Size Materials and the Errors Analysis

On the Measurement of the Elastic Constants of Small-size Samples by Ultrasonic Method

Characterization of Piezoelectric Materials Using Ultrasonic and Resonant Techniques

Development of an ultrasonic system to measure material elastic constants of small sample

Characterization of Full Set Material Constants of Piezoelectric Materials Based on Ultrasonic Method and Inverse Impedance Spectroscopy Using Only One Sample

Determination of Full Set Material Constants of Piezoceramics from Phase Velocities

Characterizing Full Matrix Constants Of Piezoelectric Single Crystals With Strong Anisotropy Using Two Samples

Determining Full Matrix Constants of Piezoelectric Crystal From a Single Sample Using Partial Electrode Electromechanical Impedance Spectroscopy

Rapidly Measuring Elastic Coefficients of New Piezoelectric Materials Using Resonant Ultrasound Spectroscopy

Design of line-focus PVDF ultrasonic transducer for elastic constant measurement of limited-size samples

Application of Air-Coupled Ultrasonic Nondestructive Testing in the Measurement of Elastic Modulus of Materials

Characterization of Full Set Material Constants and Their Temperature Dependence for Piezoelectric Materials Using Resonant Ultrasound Spectroscopy

Vibration Characteristics of Piezoelectric Ceramic Elements with Large Anisotropy and Their Application in Ultrasonic Probes

Influence of Sample Size on Ultrasonic Phase Velocity Measurements in Piezoelectric Ceramics

Quantitative Measurement Of Piezoelectric Coefficient Of Thin Film Using A Scanning Evanescent Microwave Microscope

The Development of a General Anisotropic Material Model with Resonant Ultrasound Spectroscopy Technology for the Measurement of Elastic Constants of Piezoelectric Crystals

Research on the Measurement of Elastic Constants of the Smaller-specimen Materials

Automatic performance testing of piezoelectric ceramics for power transducers

Accurate Determination of Complex Materials Coefficients of Piezoelectric Resonators