Abstract:In this paper, we tested the mechanical properties at room and high temperatures, and compared the cutting performance of three ceramic tool materials with different components added sequentially. By analyzing and comparing, the influence of material components on the changes in material mechanical properties and cutting performance is obtained, and the guidance for material system design is proposed. Three kinds of Si3N4‐based ceramic tools (single‐phase Si3N4, Si3N4/(W,Ti)C, and Si3N4/(W,Ti)C/Ni) were fabricated by microwave sintering. The phase composition, toughening mechanism, mechanical properties at room and high temperatures (800°C), and cutting performance of Si3N4‐based ceramic tool materials with different additives were investigated. The results showed that the addition of (W,Ti)C and Ni had a significant effect on improving the mechanical properties at room temperature, although it reduced the phase transition conversion rate of Si3N4. Si3N4/(W,Ti)C tools had good high‐temperature stability, while Si3N4/(W,Ti)C/Ni tools had a decrease of about 31.6% in high‐temperature hardness and a decrease of 13.7% in high‐temperature flexure strength. Under the premise of ensuring a certain level of fracture toughness, high‐temperature hardness is the main influencing factor on the cutting life of cutting tools. The Si3N4/(W,Ti)C tools exhibit superior cutting performance whose cutting life reaches to 50.67 min which was 1.37–3.27 times longer than the other two ceramic cutting tools at the same cutting parameters when continuous dry cutting T10A. In addition, high‐temperature flexure strength limits the choice of cutting speed, and lower high‐temperature flexure strength can lead to rapid tool failure.

Applications and Performance Testing of High-temperature Ceramics for Heat Engine Components

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

New Progress in the Preparation and Application of High Performance Silicon Nitride Ceramics

Extraordinary High-Temperature Mechanical Properties in Binder-Free Nanopolycrystalline WC Ceramic

Research Progress on Lightweight and High Strength Heat-Insulating Porous Ceramics

Ceramic Matrix High-Temperature Self-Lubricating Materials

Sintering, Properties and Applications of Silicon Nitride and Sialon Ceramics

Novel Low Thermal Conductivity Ceramic Materials for Thermal Barrier Coatings

Effect of SiC Content on the Ablation and Oxidation Behavior of ZrB2-Based Ultra High Temperature Ceramic Composites

Ultrahigh‐temperature tensile behaviors of ZrB2–SiC ceramics

High-temperature mechanical properties and oxidation resistance of SiCf/SiC ceramic matrix composites with multi-layer environmental barrier coatings for turbine applications

Thermal Shock and Residual Strength Testing of SiC/SiC Composite Braided Tubes

Study on Thermal Shock Resistance and Oxidation Resistance of Ultra-High Temperature Ceramics

Experimental study on high temperature performances of silica-based ceramic core for single crystal turbine blades

Experimental Investigation On Surface High Temperature Wear Behaviors Of Si3n4 Ceramics For Rotary Ultrasonic Grinding

Synthesis, Microstructure and Properties of High-Strength Porous Ceramics

Fabrication and Applications of Ceramic-Based Nanofiber Materials Service in High-Temperature Harsh Conditions—A Review

Experimental and numerical research on high‐temperature thermal insulation performance of lightweight porous ceramic/nanomaterial composite structure

Advances in Research of Rare-earth Zirconate Ceramics Used for High Temperature Insulation and Load-bearing Materials

The influence of components on the high‐temperature performance and cutting performance of Si3N4‐based ceramic tools