Abstract:Due of their excellent cathodic protection, zinc-rich coatings are among the most important protective coatings for steel substrates used in extremely corrosive and harsh maritime environments. Unfortunately, very few investigations exist on the impact of the size distribution of zinc particle on the electrochemical performances of aqueous inorganic zinc-rich coatings. Herein, we statistically analysed the particle size distribution of two differently sourced zinc powders, named X1 and X2, for coating applications. Their micro-morphologies and particle size distribution within the cross-section of the prepared coatings (designated E06-1-1/X1 and E06-1-1/X2) were investigated by scanning electron microscopy and energy-dispersive spectrometry. While X1 exhibited a relatively uneven size distribution, X2 displayed a more distinct pattern with a step-down trend. After 2200 h, the open-circuit potential (OCP) of E06-1-1/X1coating was higher than that of the Q235 steel substrate (−0.72 V), and pitting corrosion was observed on its surface after 1000 h in a neutral salt spray test. The OCP of E06-1-1/X2 was lower than −0.72 V throughout the test duration of 2500 h, and the development of pits was observed after 1300 h. From the results of coating adhesion strength, OCP, electrochemical impedance spectra, and neutral salt spray tests, the effect of zinc particle size distribution on the anticorrosion performance of the two waterborne inorganic zinc-rich coatings was systematically investigated. The results show that improvements in zinc powder dispersion in coatings are related to the uniformity of zinc particle size distributions. Consequently, this increases the surface area at the interfaces between zinc powder and metal. Furthermore, zinc powders with consistent particle size distributions are better able to provide metal substrates with cathodic protection, while also affording water-based inorganic zinc-rich coatings prolonged anticorrosion effects. Therefore, this study advances the protection mechanism of zinc-rich coatings.

Effects of Four Kinds of Powders on Corrosion Resistance of Alcohol-Soluble Inorganic Zinc-Rich Paints

The Effect of Suspended Particles on the Corrosion Resistance of Electrodeposited Zinc Powders

Effect of Lamellar Zinc Powders on Properties of Alcohol-Soluble Inorganic Zinc-Rich Coating

Effect of Aluminum Powders on Properties of Alcohol-soluble Inorganic Zinc-rich Coating

Effect of Zinc Powder Reduced Graphene Oxide on the Corrosion Resistance of Waterborne Inorganic Zinc-Rich Coatings

Effects of the particle size distribution of zinc powder on the anticorrosion performance of water-borne inorganic zinc-rich coatings

A Comparative Study on the Anti-Corrosive Performance of Zinc Phosphate in Powder Coatings

Impact of inhibitor loaded with pigments content on properties of inorganic zinc rich coatings

A Mechanistic Study on the Anti-Corrosive Performance of Zinc-Rich Polyester/TGIC Powder Coatings

Effect of iron powder on zinc reactivity and anticorrosion performance of zinc-rich epoxy coatings

Influence of Zinc Content on Anti-Corrosion Performance of Zinc-Rich Coatings

Zinc-rich Polyester Powder Coatings with Iron Phosphide: Lower Zinc Content and Higher Corrosion Resistance

Electrochemical Behavior of Organic and Inorganic Zinc-Rich Coatings in 3.5% NaCl Solution

Enhanced Anticorrosion Properties of Epoxy Coatings from Al and Zn Based Pigments

Effects of P/B on the Properties of Anticorrosive Coatings with Different Particle Size

STUDY OF THE ELECTROCHEMICAL BEHAVIORS OF THE ZINC-RICH PAINTS BASED MULTILAYER ORGANIC COATINGS IN NaCl SOLUTION

Improving the performance of zinc-rich coatings using conductive pigments and silane

Structure and Corrosion Resistance of Inorganic Zinc Silicate Coatings Based on Super-Fine Zinc Powder

EFFECT OF ALUMINUM POWDER ON PERFORMANCE OF ORGANIC SILICON PAINT

Effects of the Size of Zinc Powder and Mixing on the Property of Zn-Cr Coating Paint

Effect of ZnO on Properties of Alcohol-soluble Inorganic Zinc-rich Coating