Abstract:Purpose Selective laser sintering (SLS) is an essential technology in the field of additive manufacturing. However, SLS technology is limited by the traditional point-laser sintering method and has reached the bottleneck of efficiency improvement. This study aims to develop an image-shaped laser sintering (ISLS) system based on a digital micromirror device (DMD) to address this problem. The ISLS system uses an image-shaped laser light source with a size of 16 mm × 25.6 mm instead of the traditional SLS point-laser light source. Design/methodology/approach The ISLS system achieves large-area image-shaped sintering of polymer powder materials by moving the laser light source continuously in the x-direction and updating the sintering pattern synchronously, as well as by overlapping the splicing of adjacent sintering areas in the y-direction. A low-cost composite powder suitable for the ISLS system was prepared using polyether sulfone (PES), pinewood and carbon black (CB) powders as raw materials. Large-sized samples were fabricated using composite powder, and the microstructure, dimensional accuracy, geometric deviation, density, mechanical properties and feasible feature sizes were evaluated. Findings The experimental results demonstrate that the ISLS system is feasible and can print large-sized parts with good dimensional accuracy, acceptable geometric deviations, specific small-scale features and certain density and mechanical properties. Originality/value This study has achieved the transition from traditional point sintering mode to image-shaped surface sintering mode. It has provided a new approach to enhance the system performance of traditional SLS.

Investigation on powder paving process of SLS

Study on the numerical simulation of laying powder for the selective laser melting process

In-situ experiment tests and particulate simulations on powder paving process of additive manufacturing

Study on the Process Parameters of Selective Laser Sintering Foundry Silica Sands

Research on numerical simulation and experimental for temperature fields of thin layer powder with selective laser sintering

Powder-spreading dynamics and packing quality improvement for laser powder bed fusion additive manufacturing

Experimental Research on Influence of Compactness in SLS of PA6 Powder Material

Dynamics of short fiber/polymer composite particles in paving process of additive manufacturing

Improvement on Selective Laser Sintering and Post-Processing of Polystyrene

Research and implementation of large-area sintering technology based on image-shaped laser

Advances in Thermal Modeling of Selective Laser Sintering of Metal Powders

The Role of Roller Rotation Pattern in the Spreading Process of Polymer/Short-Fiber Composite Powder in Selective Laser Sintering

The influence of material properties and process parameters on the spreading process in additive manufacturing

Simulation and Experimental Analysis of the Laser Sintering of Nylon Powder

Experimental and computational study on thermal and fluid behaviours of powder layer during selective laser melting additive manufacturing

Experimental Study on Technological Parameters and Proportion of Selected Laser Sintered PS/PE Mixed Powders

Multi-scale phase-field modeling of layer-by-layer powder compact densification during solid-state direct metal laser sintering

Process parameters analysis of direct laser sintering and post treatment of porcelain components using Taguchi's method

Metal powders of selective laser sintering

Research on Forming Quality of AlSi10Mg Powder for SLM Process

Comparisons of Indirect Selective Laser Sintering with Selective Laser Melting