Abstract:The main objective of the present article is to obtain the optimum technological parameters of the automobile plastic front-end frame. Moldflow software was used to simulate the injection molding of the automobile plastic front-end frame bracket in this study. The uniformity experiment was designed and completed. Five injection molding process parameters, including mold temperature, melt temperature, packing pressure, injection time, and packing time, were selected as experimental factors. Volume shrinkage and warpage amount were selected as quality evaluation indexes. Statistical Product Service Solutions (SPSS) software was used to perform linear regression analysis on the test results, respectively, and the linear regression equation corresponding to the two evaluation indexes was obtained. Then, regression equation analysis was carried out to obtain the optimal process parameter combination of the volume shrinkage and the warpage amount. A back propagation (BP) neural network model with input as a process parameter and output as an evaluation index is established by MATLAB and optimized by a genetic algorithm (GA). Finally, the optimized neural network model was used to predict the combination of process parameters with the minimum volume shrinkage and warpage amount. Based on the performed simulations, the minimum volume shrinkage and the minimum amount of warping in the optimal design were 13% and 0.7062 mm, respectively. The corresponding combination of process parameters was the mold temperature of 75.5°C, the melt temperature of 285.32°C, the packing pressure of 42.32 MPa, the injection time of 3.45 s, and the packing time of 60 s. According to the optimal process parameters, the volume shrinkage and warpage amount of the automobile plastic front-end frame have reached the optimal state at the same time, which improves the quality of injection molding and reduces production and processing costs. It has a certain guiding significance.

Research on the Relationship Between Process Parameters and Injection Molding in Polymer Metal Hybrid Technology

Multi-objective Robust Optimization of Injection Molding Process Parameters Based on TOPSIS

Hybrid Integration of Taguchi Parametric Design, Grey Relational Analysis, and Principal Component Analysis Optimization for Plastic Gear Production

Research on the Effects of Process Parameters on Shrinkage Variation of the Rapid Heat Cycle Molding Plastic Part

Design and Parametric Optimization of the Injection Molding Process Using Statistical Analysis and Numerical Simulation

Numerical Optimization of Shrinkage and Warpage on the Injection Molding Process Parameters of Electrical Connector

Effect of Process Parameters in Rapid Heat Cycle Molding Produce on the Replication Fidelity of Plastic Part

The Influential Effect of Molding Parameters on Quality of Part Manufactured by Rapid Heat Cycle Molding Technology

Optimization of Injection Molding Processing Parameters of Display Shell Based the Orthogonal Experiment

Integrated Numerical Simulations and Experimental Measurements for the Sintering Process of Injection-Molded Ti-6Al-4V Alloy

Optimization of injection molding process parameters to improve the mechanical performance of polymer product against impact

Effect of processing parameters, antistiction coatings, and polymer type when injection molding microfeatures

A Process Parameters Optimization Method for Injection Molding Based on Classification Model

Research on Optimization of Injection Molding Process Parameters of Automobile Plastic Front-End Frame

Determination of Optimal Process Parameters for Plastic Injection Molding of Polymer Materials Using Multi-Objective Optimization

Process Parameters Optimization Using a Novel Classification Model for Plastic Injection Molding

Intelligent Methods for the Process Parameter Determination of Plastic Injection Molding

Warpage analysis and optimization of thin-walled injection molding parts based on numerical simulation and orthogonal experiment

Optimize Injection-Molding Process Parameters and Build an Adaptive Process Control System Based on Nozzle Pressure Profile and Clamping Force

Numerical Simulation and Process Optimization of a 3D Thin-Walled Polymeric Part Using Injection Compression Molding

Effect of processing parameter changes on mechanical properties during injection molding: Amorphous versus semi‐crystalline materials