Abstract:This study investigates the effect of pressure on diffusion creep of dry San Carlos and synthetic (prepared by sol-gel method) olivine. We prepared dry (water content < 9 ppm wt) fine-grained (< 1 μm grain-size) olivine and deformed the samples (both San Carlos and solgel olivine in the same assembly) in the same sample assembly under high-pressure ( P = 2.9–8.8 GPa) and modest temperatures ( T = 980–1250 K) at a fixed strain-rate. Evolution of strength was studied using the radial X-ray diffraction from various diffraction planes. We found that San Carlos and sol-gel olivine show similar rheological behaviour (when normalized to the same grain-size). Stress estimated by the radial X-ray diffraction increases with time and initially shows similar values for all diffraction planes. In many cases, stress values start to depend on the diffraction planes in the later stage and time dependence becomes minor. The micro-structural observations show that grain-size increases during an experiment. The results are interpreted using a theory of radial X-ray diffraction and the theoretical models of diffusion and dislocation creep. We conclude that the initial stage of deformation is by diffusion creep, but deformation in the later stage is by dislocation creep. For dislocation creep, our results are in reasonable agreement with previous low temperature dislocation creep results after a correction of temperature effect. For diffusion creep, we obtain an activation volume of 7.0 ± 2.4 cm 3 /mol that is substantially smaller than the values reported on dislocation creep but agrees well with the results on grain-growth. By comparing the present results on dry olivine with the previous results on wet (water-saturated) olivine, we found that water enhances diffusion creep but only modestly in comparison to dislocation creep. The difference in the pressure and water content dependence between diffusion and dislocation creep has an important influence on the dominant deformation mechanisms of olivine in the upper mantle.

Harper-Dorn creep in olivine

Harper-dorn creep in polycrystalline ferrite, beryllia, alumina, calcite and olivine

New Constraints on Upper Mantle Creep Mechanism Inferred from Silicon Grain-Boundary Diffusion Rates

On the Transition from Power-Law Creep to Diffusional Creep

Experimental-Evidence For Harper-Dorn Creep In Mn-Zn Ferrite

Dislocation Mobility in Ringwoodite As a Function of Temperature and Water Content

Microstructural and Micromechanical Evolution of Olivine Aggregates During Transient Creep

Comments on the internal stress model of Harper-Dorn creep

Plastic deformation of dry fine-grained olivine aggregates under high pressures

Observations of grain size sensitive power law creep of olivine aggregates over a large range of lattice‐preferred orientation strength

On The Transitions Among Different Creep Regimes

Dependence of dislocation density in Harper-Dorn creep on the peierls stress

Grain boundary sliding in compressed olivine aggregates.

Transient and steady-state dislocation creep of olivine controlled by dislocation interactions at the isostress endmember

High-temperature creep in a Ni 2 GeO 4 : a contribution to creep systematics in spinel

The Effect of Physical and Chemical Environment on Rheological Behavior of Olivine Aggregates

Establishment of a steady dislocation density by the Peierls stress in Harper-Dorn creep

Theories of Creep in Ceramics

High‐Temperature Deformation of Enstatite‐Olivine Aggregates

The Effect of Pressure on the Rheology of Olivine