Abstract:The high temperature thermoplastic of the container plate was studied by Gleeble-3500 thermal simulator.The taper,heat flux,narrow-width heat flux ratio,the protective slag and rolling process were optimized in the continuous casting process.The results show that the straightening temperature is above900 ℃ in the process of the container plate molten steel casting,the speed is controlled at 4.0～4.3 m/min,and the weak cooling mode is used in the second cold stage.When the taper is controlled at 1.45～1.63 ％/m,the heat flux of the wide surface is 1 800～2 200 kW/m2,the narrow width heat flux ratio is 70％～85％,the protective slag's basicity is 1.13,the heat flux is the most stable and the occurrence rate of cold tooth is the lowest rate.Using the cooling way in the front section,the rolling force of F4 is controlled at 1 100～1 300 t,the rolling force of F5 is controlled at 900～1 000 t.The temperature of RDT is controlled to 1 070～1 120 ℃,the descaling pressure is adjusted to 32 MPa before rough rolling,the descaling pressure was adjusted to 34 MPa before finish rolling.The average yield strength of the container plate is 438 MPa,the average tensile strength is 519 MPa,and the average elongation is 35.9％ after optimization.

Analyses of Automatization Welding Technology of Transver and Girth Seam in Al_2O_3 Container Body

Study on double-side automatic welding technology and equipment of girth seam of container body

AUTOMATIC WELDING TECHNOLOGY AND EQUIPMENT OF TRANSVERSE GIRTH SEAM FOR METALLURGICAL BLAST-FURNACE BODY

Study on Welding Technology and Welded Joint's Properties of 20G Aluminized Steel Tube

Study of Technology and Equipment of Electrogas Welding of High Efficiency in Thick Plate of Ship

Combination of Thin-walled Shell Welding Manufacturing Technology

Study on Automatic Control System of Sealing Machine for Metallic Fuel Tank

STUDY OF ELECTROGAS ARC WELDING TECHNIQUE FOR MAJOR DIAMETER THICK-WALLED PIPE

Study on MAG Welding Process in Single-side Welding with Double-face Formation for Dissimilitude Thick Steel Sheet

Development of Thin Gauge Container Plate Producted by Thin Slab Casting and Rolling Production Line

Microstructural Characterization of 5083 Aluminum Alloy Thick Plates Welded with GMAW and Twin Wire GMAW Processes

Welding Procedure and Deformation Control Technology on Large Oblique Nozzle to Shell Joint of Gasifier

Reliability Analysis and Evaluation of Automobile Welding Structure

Optimization design and application analysis of automatic welding rolling device

Key technologies and automation system for large-scale aerospace component welding

Research of automatic welding control system for thick-thin steel plate butt joint

Analysis of Automobile Body Structure and Monocoque Body Welding Technology

New development in welding thin-shell aluminum alloy structures with high strength

Research Status of Arc Welding Technology of Galvanized Sheet for Automobile

Study on the hinged welding technology of HG785D thin-wall grooved parts

DEVELOPMENT OF AUTOMATIC WELDING SYSTEM FOR THE COMPRESSOR SHELLS OF THE AIR CONDITIONS