Three-dimensional Modeling and Simulation of RF Cavity for a Transmitter with Bandwidth of 40–100 MHz at 100-Kilowatt Level
Guanghui Zhu,Liangliang Li,Ji Guo,Hezhu Wang,Xinjun Zhang,Jinxin Wang,Yuzhou Mao,Chengming Qin,Wei Zhang,Lunan Liu,Yan Cheng,Shuai Yuan,Shidong Wei,Hang Li,Chang Chen,Jingting Luo
DOI: https://doi.org/10.1016/j.fusengdes.2023.113566
IF: 1.905
2023-01-01
Fusion Engineering and Design
Abstract:A 1.5 MW final power amplifier is to be developed for ion cyclotron resonance heating (ICRH) system for the China fusion engineering testing reactor (CFETR) project. First, the feasibility of driver power amplifier with input matching circuit and output resonator cavity and a newly developed tetrode was cross-verified through three-dimensional (3D) simulations and experiments. A single coaxial cavity in parallel with the tetrode covered the frequency range of 40 to 100 MHz at a 100-kilowatt level. In contrast to the previous method of deducing matching parameters using RF circuit and transmission line theory, the use of 3D transmitter simulations pro-vided more accurate matching parameters of tuning components at different operating frequencies. A new phenomenon of high frequency oscillation between the short strip inductor and the shield cavity was found in the input simulation results, which was subsequently verified by experiments. Specific reasons for dividing the output into two parts of high and low frequency were found through output circuit simulations. One is that the length of short stub decreases with the increase of operating frequency, thus decreasing the frequency resolution if all frequencies were using low frequency port. The other is that the coupling capacitor increases sharply with the increase of frequency due to parasitic effect in the low output. Further, the simulation facilitated the study of parasitic effects on matching parameters caused by strip-inductance, inter electrode capacitances of tetrode, and RF cavity. Thus, facilitating the design of final power amplifier in the future. Finally, the amplifier installed with the new tetrode DB968 achieved the design objectives in the test experiment with 150 and 110 kW power outputs at 48 and 100 MHz, respectively.