Dynamic Tensile Properties of Porcine Ham Muscle

HU Shi-sheng

2010-01-01

Abstract:The tensile stress-strain curves of porcine ham muscle along the longitudinal and transverse directions of the muscle fibre were obtained over a wide range of strain rates(0.02～2 100s-1).The experiments were performed by using the biomechanical testing system and the polymeric split Hopkinson tensile bar(SHTB)in the tubes.A program was compiled to modify the effect of dispersion and attenuation of waves in the viscoelastic polymeric bar used as the transmission bar in the dynamic experiments.Statistical analyses were done by using one-way ANOVA(p0.05).The results show that the flow stress of the porcine ham muscle at the high strain rate of 2 100s-1 is both apparently higher than that at the low strain rate of 0.02s-1 along the two loading directions,illustrating the strain rate sensitivities of the porcine ham muscle.At the low strain rates,the ultimate strengths along the longitudinal direction are higher than those along the transverse direction,whereas there are no significant differences between their failure strain values.The quasi-static stress-strain curves behave as the other soft tissues,exhibiting an initial non-linear"toe"region,followed by a linear region and subsequently a nonlinear region prior to the gradual failure.At the high strain rates,the"toe"region vanishes because it has no enough time to permit the straightening of the helical structure.The initial modulus in the transverse direction is much higher than that in the longitudinal direction.However,when the strain increases,the flow stresses in the two directions have no significant difference and the flow stress in the longitudinal direction gradually inclines to higher than that in the transverse direction.