Abstract:A novel experimental technique conducted at a modified automatic split Hopkinson pressure bar (SHPB) for measuring the dynamic compressive behavior at ultra-high temperature up to 1700 °C was developed. A bidirectional electric synchronous assembly system, two high-precision delay controllers and an automatic control mechanism were employed to automate each section in the whole experiment process with high precision and high reliability. The cold contact time (CCT) between specimen and loading bars can be accurately and stably controlled to be shorter than 5 ms and the effect of CCT on temperature distribution can be eliminated. Based on this automatic high-temperature SHPB technique, an experimental investigation into the responses of a new in-service single-crystal Nickel-base superalloy DD10 subjected to impact loading at high temperature was undertaken. The influence of strain rate and temperature on the flow behavior of DD10 was tested and analyzed over a wide range of strain rate (0.001/s-4000/s) and temperature (25°C–1200 °C). The high temperature has an evident effect on the flow stress, strain hardening and strain rate sensibility. An anomalous peak of stress in true stress–temperature curve can be found, and the peak temperature increases with strain rate increasing. Through the microstructural observation, the influence of strain rate and temperature on the compressive deformation and fracture mechanism was discussed. At the high temperature above 1000 °C, the shear deformation mechanism of both γ matrix phase and γ′ precipitate phase is the dominant deformation mechanism at high strain rate, instead of the rafting mechanism of γ′ precipitate phase of under quasi-static loading condition.

Study on Impact Compressive and Tensile Mechanical Properties of HTPB Composite Base Bleed Grain at Various Temperatures

Study on the Mechanical Performances of Carbon Fiber/epoxy Composite Material Subjected to Dynamical Compression and High Temperature Loads

Experimental study on dynamic behavior of concrete at elevated temperatures

Validity analysis of materials' dynamic tensile SHTB experimental technique at ultrahigh temperature

Effects of strain rate and temperature on mechanical properties of TP-650 composite

Tensile Mechanical Properties of HTPB Propellant at Low Temperature

Compressive mechanical properties of HTPB propellant at low, intermediate, and high strain rates

Plastic Behavior and Constitutive Relations of DH-36 Steel over a Wide Spectrum of Strain Rates and Temperatures under Tension

A New Technique for Conducting Split Hopkinson Tensile Bar Test at Elevated Temperatures

Dynamic Compressive Behavior of a Single Crystal Nickel-Base Superalloy at Ultra-High Temperature: Mechanism Investigation with a Modified Electric Synchronous SHPB Technique

Coupled Effects of High Temperature and Strain Rate on Compressive Properties of Hybrid Fiber UHTCC

Dynamic Mechanical Response, Energy Absorption Capacity, and Constitutive Modeling of Polypropylene Fiber-Reinforced Foamed Concrete under High Temperature

Analysis of Mechanical Properties for AP/HTPB Solid Propellant under Different Loading Conditions

High temperature mechanical properties of TiC particle reinforced titanium composites

Temperature Effect on Dynamic Compression Performance of Random Fibrous Composites in the TTT and IP Directions

Research on the viscoelastic constitutive model of HTPB propellant over a wide range of strain rates

High Strain Rate Effect Of Carbon Fiber Laminates Under Hygrothermal Environment

Biaxial Tensile Mechanical Properties of HTPB Solid Propellant

Experimental Research on Dynamic Mechanical Behavior of TC18 Titanium Alloy under Medium and High Strain Rates

Strain Rate and Temperature Effect on Mechanical Properties and Failure of 3D Needle-Punched Carbon/Carbon Composites under Dynamic Loading

MECHANICAL PROPERTIES OF PLAIN HIGH-STRENGTH HIGH-PERFORMANCE CONCRETE UNDER BIAXIAL COMPRESSION AFTER EXPOSURE TO HIGH TEMPERATURES