Abstract:Direct Laser Interference Patterning (DLIP) allows the creation of submicrometric periodic structures by taking advantage of the light interference phenomenon. In this study, DLIP is applied to the surface of zirconia using a picosecond laser source to create a 3 μm periodic line‐like texture. The fabrication of periodic hierarchical structures in zirconia is demonstrated for the first time. The functionalization of zirconia surfaces by accurate and fast printing of periodical patterns embedding sub‐micrometric features is of great interest to many engineering fields and is yet to be explored. This study aims to assess the influence of the Direct Laser Interference Patterning processing parameters on the morphology and microstructure of zirconia surfaces using a 532 nm 10 ps‐pulsed laser source. Well‐defined linear structures with a period of 3 μm are successfully produced. Depending on the laser parameters, the structures are developed at or below the surface level, with higher depths (≈1 μm) being seen for increasing values of laser fluence and pulse overlap. Line‐like hierarchical structures with smaller interference spatial structures (3 μm period) and higher secondary structures with different periods (18, 15, and 12 μm) and heights (7, 5, and 3 μm, respectively) are also obtained on zirconia surface. Ablated regions presented few traces of molten material, nano‐droplets, and sub‐micrometric (<1 μm) pores, while no (sub) micrometric cracks are detected. A slight amount of tetragonal to monoclinic phase transformation (≈5%) is detected by X‐ray diffractometry. A processability map for ps‐laser processing of zirconia is proposed based on the experimental data.

Two-Dimensional Dfb Laser Fabricated on Dye-Doped Hybrid Zirconia Film by Soft Lithography

Fabrication of Optical Cavities with Femtosecond Laser Pulses

Design of an Optically Pumped Distributed Feedback Laser with Perovskite Active Media

Distributed Feedback Sol-Gel Zirconia Waveguide Lasers Based on Surface Relief Gratings.

An Experimental Research about Dye-Doped Distributed Feedback Laser

Analysis and Design of Combined Distributed-Feedback/fabry-perot Structures for Surface-Emitting Semiconductor Lasers

Hybrid Structure Laser Based on Semiconductor Nanowires and a Silica Microfiber Knot Cavity

The Performance of Dye-Doped Zirconia-ORMOSILs Films

Distributed-feedback laser actions in zirconia-ORMOSIL waveguides based on energy transfer between co-doped laser dyes

A Nano-Patterned Photonic Crystal Laser With A Dye-Doped Liquid Crystal

Fabrication of Multiscale and Periodically Structured Zirconia Surfaces Using Direct Laser Interference Patterning

Fabrication of two dimensional high aspect ratio polymer photonic crystal laser

Intracavity Frequency Doubling of A New Low-Threshold High-Efficiency Crystal Nd:Sr-5(Po4)(3)F

Direct Writing of Buried Waveguides in Hybrid Organic-Inorganic Sol-Gel by Femtosecond Laser Pulses

Fabrication of Integrated Single Frequency DBR Fiber Laser Directly on YDF by Femtosecond Laser

High-Performance Whispering Gallery Microcavities Fabricated by Direct Laser Writing

Two-Dimensional Simulation of High-Order Laterally-Coupled Gaas-Algaas Dfb Laser Diodes

1.3 Μm Laterally-Coupled Distributed Feedback Laser with a Triangular Prism Etched Facet

A Multiple Phase-Shifted Distributed Feedback (dfb) Laser Fabricated by Nanoimprint Lithography

Laser-induced periodic surface structures as optical resonators for organic thin-film distributed feedback lasers

High Quality Direct Photo-Patterned Microdisk Lasers with Organic-Inorganic Hybrid Materials