Abstract:Shunt active power filters are the most viable solution for solving current harmonic, reactive power compensation, and load unbalancing problems widely presented in electrical distribution systems. In this article, development and implementation of a digital signal processor based three-phase four-wire shunt active power filter are analyzed to compensate non-linear and unbalanced loads under non-ideal supply voltages conditions. The proposed algorithm is divided into two parts, the first associated with the calculation of the positive-sequence component of unbalanced supply voltage and second deriving a simple and attractive fundamental extraction filter to extract the fundamental frequency component from distorted positive-sequence voltage. Average power and DC-link energy balance methods are used to calculate peak value of the supply current, which is required to flow from source to load. The behavior and effectiveness of the proposed control algorithm has been verified by simulation using MATLAB/Simulink (The MathWorks, Natick, Massachusetts, USA) environment for different cases of supply voltage. A laboratory prototype has been developed to verify the simulation results. The control scheme is realized using a TMS320F28335 floating-point digital signal processor (Texas Instruments, Dallas, Texas, USA) based system. It is found that simulated and experimental harmonic spectral performances are in compliance with the recommendations about harmonic limits imposed by the IEEE-519 Standard.

A Monitor System for Hybrid Active Power Filter Based on Labview

Unified Model Based Harmonics and Reactive Current Detection

High temperature proton exchange membrane fuel cell hybrid power system monitoring platform designing

Monitor System of Energy-Feedback Electronic Load Based on CAN Bus and LabVIEW

Design of monitor and control system for a segment assembly test bed of shield machine

Design and Realization of HMM-based Power Transformer Fault Diagnosis System Software

Automatic Testing and Control System for Electro-Hydraulic Proportional Displacement Pump Based on LabVIEW

A novel shunt active power filter system

An Improved Harmonic Detection Based On Lead Compensation For Active Power Filter

Design of Monitoring System for Microgrid of Wind-Hydrogen-Fuel Cell Based on KingView Software

The Research Status and Prospect of Hybrid Var Compensator and the Filter Combined System

Improvement in Power Quality Using Hybrid Power Filters Based on Robust Extended Kalman Filter

A Multi-Modular Shunt Active Power Filter System and Its Novel Fault-Tolerant Strategy Based on Split-Phase Control and Real-Time Bus Communication.

A Novel Hybrid Active Power Filter Based on Coupling Inductor

Study on a novel hybrid active power filter

Study on a transformerless Hybrid Active Power Filter with high compensation precision and dynamic performance

A NEW HARMONICS DETECTION DESIGNING FOR HYBRID ACTIVE POWER FILTER OF FINITE HARMONIC IMPEDANCE

A Digital Signal Processor Based Performance Evaluation of Three-phase Four-wire Shunt Active Filter for Harmonic Elimination, Reactive Power Compensation, and Balancing of Non-linear Loads under Non-ideal Mains Voltages

Implementation of Harmonic Detection and Remote Transmission Based on Virtual Instruments

The Design and Research of the Hybrid Active Power Filters

A Computer Control And Monitoring System For High Power Converters