Abstract:The paper reports numerical investigation of room temperature, active magnetocaloric regeneration (AMR) refrigerators/heat pumps using microchannel regenerator. The microchannel regenerators are made of a magnetocaloric material (MCM), Gd, with diameter of the circular channels ranging from 0.7 mm to 2.0 mm. Water, the working fluid, oscillates in the regenerator loop driven by two piston-cylinder displacers operating in a range of mass flow rates. Three dimensional conjugated fluid convection and conduction heat transfer in the microchannel regenerator was modeled and numerically simulated using ANSYS Fluent. The magnetocaloric effect (MCE) was incorporated into conservation of energy using a discrete method to simulate the magnetization and demagnetization of the MCM. The hot and cold end heat exchangers were treated with the e-NTU method. Effects of utilization and porosity of the microchannel regenerator and cycle frequency on the cooling capacity and temperature span were examined. When the utilization, porosity and cycle frequency are 0.2, 0.5 and 5.0 Hz, respectively, the predicted maximum cooling capacity was about 22 W for a 0.8 T variation in intensity of magnetic field. The effects of magnetic field intensity, reservoir temperature span and flow rate profile on the refrigeration performance were also investigated. The performance of the microchannel regenerator is compared with that of the parallel plate regenerator for the no-load temperature span, cooling capacity and pumping power. Under specific geometric and operating conditions, the microchannel regenerator shows better performance than the parallel plate one. (C) 2016 Elsevier Ltd. All rights reserved.

Dynamic Simulation Of Magnetic Material Regenerator And Comparison With Experiment

Hydrogenation-induced variation in crystal structure and heat capacity of magnetic regenerative material Er3Ni

Hydrogenation Induced Change in Structures, Magnetic Properties and Specific Heats of Magnetic Regenerative Material Erni and Erni2

Numerical Investigation of a Packed-Bed Active Magnetic Regenerator

Performance Enhancement of Latent Thermal Energy System under Alternating Magnetic Field

Performance Simulation of the Active Magnetic Regenerator under a Pulsed Magnetic Field

Numerical simulation of a multistage magnetic refrigeration system in the temperature range of liquid hydrogen

Performance Prediction of Active Magnetic Regenerator of Room Temperature Magnetic Refrigeration

Numerical Investigations on Internal Temperature Distribution and Refrigeration Performance of Reciprocating Active Magnetic Regenerator of Room Temperature Magnetic Refrigeration

Simulation of Magnetic Hysteresis Loops and Magnetic Barkhausen Noise of Α-Iron Containing Nonmagnetic Particles

Numerical Modeling of an Active Elastocaloric Regenerator Refrigerator with Phase Transformation Kinetics and the Matching Principle for Materials Selection

Thermodynamic modeling, material selection, and new dimensioning of a multilayer regenerator for a magnetic refrigeration system

A Multi-Parameter Model of Heat Treatment Process for Soft Magnetic Materials on Performance of HSERs

Spin-lattice-electron Dynamics Simulations of Magnetic Materials

2-D Models of Magnet and Active Magnetocaloric Regenerator.

Numerical Investigation of Room Temperature Magnetic Refrigerator Using Microchannel Regenerators

Time Dependent Model to Analyze the Magnetic Refrigeration Performance of Gadolinium Near the Room Temperature

Numerical analysis of an active magnetic regenerator with parallel wire geometry based on a 1D AMR model

Experimental Study on Cooling Performance of Active Magnetic Regenerators with Different Structures

Magneto-thermal coupling simulation and experimental verification for a three-winding high-frequency transformer

Numerical Simulation of Magnetic Field for Compact Electromagnet Consisting of REBCO Coils and Iron Yoke